Kramer VIA GO Quick Start Manual

STEP 2: Install the VIA GO

Place the VIA GO on a table or mount in a rack with optional adapter RK-CONNECT PRO.
Note that when using the built-in Wi-Fi module, we recommend installing the VIA GO unit
on a table, for better RF transmission.

STEP 3: Inputs and Outputs at a Glance

Always switch o the power on each device before connecting it to your VIA GO.

VIA GO QUICK START GUIDE

For Installer

This guide helps you install and use your product for the rst time.
For more detailed information, go to www.True-Collaboration.com to download the

latest manual or scan the QR code above.

STEP 1: Check What’s in the Box

1. VIA GO Collaboration Device

2. Power supply (19V DC) with power cord

3. Quick Start Guide

4. Mini-DP to VGA

Wireless Router

(optional) or LAN

Network

MacBook/Laptop

Android Device

iOS Device

HDMI

Output

Mini DP

Output

Mouse Keyboard

Windows Phone

ChromeBook

SS

www.KramerAV.com

Always use Kramer high-performance cables for connecting AV equipment to the VIA GO.

STEP 4: Connect the Unit

• Connect keyboard and mouse

• Connect your display

• Connect a Local Area Network (LAN) cable for connection to your network.

Alternatively, use the built-in Wi-Fi.

• Connect the power supply

• Turn on the device

STEP 5: Congure VIA GO

Your device is congured in Access Point mode, by default. In this mode, the device creates

an autonomous Wi-Fi network (SSID) named “VIA_WIFI”. The default password of this SSID is
“123456789”.

To change these default settings and congure your own VIA GO, open the main menu and click

Settings.

Enter password: supass.

The Settings Menu tabs are:

• LAN Settings – If using your VIA GO with a LAN connection, congure your network

parameters and apply the settings before rebooting your device (DHCP is enabled by default).

• System Controls – Manage your display and audio settings, run control panel,

select your language, etc.

• WiFi (when using built-in WiFi capability) – Activated by default as “Standalone WiFi”. Toggle

the “On/O” button to completely deactivate the built-in Wi-Fi module. Wi-Fi can be used in the

following modes:

1. AP Mode (default): Change or create your SSID for your wireless network and select your

preferred Wi-Fi channel for this network:

• Setup your Wi-Fi module as a secondary Access Point (for guests) and “Enable Internet”

for these users (if the primary LAN network is connected to the Internet)

• Select “Standalone Wi” to create an autonomous network (without Internet access)

• Click Apply before rebooting your device

2. Client Mode: Attach your VIA GO as a client device to your main network:

• Browse for and select an available network

• Enter the required password

• Click Apply

• Disconnect the LAN cable (if connected)

• Reboot your device

www.KramerAV.com