Page 1
The Kramer T3F-1S Inner Frame
i
Congratulations on purchasing your Kramer T3F-1S inner frame for the TBUS-3xl Table
Connection bus.
The T-2INSERT Kit Option (80-00006699)
You can install the T-2INSERT kit (which includes 1 pass-through insert and a blank insert)
instead of a power socket.
The T3F-1S inner frame includes:
• An opening for 1 power socket • One 3.5mm mini jack AUDIO connector
• 1 RJ-45 Ethernet connector • 1 VGA 15-pin HD connector
• 1 USB connector
Installing the assembled Inner Frame
To install the T3F-1S inner frame:
1. Place the assembled inner frame inside the TBUS-3xl enclosure.
2. Set the required height using your fingers to bring the inner frame to the desired
position, screw and tighten it in place using the height adjustment screws supplied with
the inner frame.
Connecting the Cables
To connect the cables:
1. Insert the cables to their appropriate connectors from underneath.
2. Secure the cables to the tie holes on the TBUS-3xl.
Do not secure the cables too tightly or too loosely. Leave a small amount of slack.
After the TBUS-3xl is connected to mains power and the proper cables, it is ready for use.
Adjusting the Height of the Inner Frame
If needed, you can adjust the inner frame height to accommodate large or bulky cables. To
adjust, perform the following:
Figure 1: T3F-1S Inner Frame (P/N: 80-002999)
Power Socket and Power Cord Options
Various power sockets and power cords are available to use with the T3F-1S, as described in
the “TBUS Modular Power Socket Installation and Power Cord” Installation Instructions,
supplied with the power socket.
Each power socket comes with detailed assembly instructions.
1. Remove the four height adjustment screws (two screws on each side), while supporting
the frame from underneath with your fingers.
2. Raise or lower the connecting surface to the required height, insert the screws, and
tighten them in place.
Page 2
!
SAFETY WARNING
Disconnect the unit from the power
supply before opening and servicing
KRAMER ELECTRONICS LTD.
Installation
Instructions
MODEL:
For the latest information on our products and a list of Kramer
distributors, visit our Web site where updates to this user manual may be
found.
We welcome your questions, comments, and feedback.
Web site:
E-mail:
www.kramerelectronics.com
info@kramerel.com
T3F-1S
Inner Frame
P/N: 2900-300063 Rev 3
Loading...