The Kramer T3F-1C Inner Frame
An opening for 1 power socket
A 4-cable pass-through insert
Each power socket comes with detailed assembly instructions.
Go to http://www.kramerelectronics.com/support/product_downloads.asp to
check for up-to-date user manuals and the complete list of Kramer wall plates
and module connectors.
i
i
Congratulations on purchasing your Kramer T3F-1C inner frame for the TBUS-3xl Table
Connection bus.
The T3F-1C inner frame includes:
Figure 1: T3F-1CInner Frame (P/N: 80-003199)
Power Socket and Power Cord Options
Various power sockets and power cords are available to use with the T3F-1C, as described in
the “TBUS Modular Power Socket Installation and Power Cord” Installation Instructions,
supplied with the power socket.
Installing the assembled Inner Frame
To install the T3F-1C inner frame:
1. Place the assembled inner frame inside the TBUS-3xl enclosure.
2. Set the required height using your fingers to bring the inner frame to the desired
position, screw and tighten it in place using the height adjustment screws supplied with
the inner frame.
Inserting Pass-through Cables
To insert the pass-through cables (for example, to connect a laptop) do the following:
1. Remove the four screws attaching the split pass-through bracket.
2. Remove the split grommet(s).
3. Insert the cable(s) through the rectangular opening.
4. Open the split grommet slightly and insert the required cables.
5. Place the split bracket around the grommet and position this assembly over the inner
frame.
6. Place the four screws appropriately and tighten the split bracket together with the
grommet and inserted cables to the inner frame.
7. Insert the self-locking ties through the tie holes to secure the cables to the inside walls
of the enclosure.
Adjusting the Height of the Inner Frame
If needed, you can adjust the inner frame height to accommodate large or bulky cables. To
adjust, perform the following:
1. Remove the height adjustment screws, while supporting the frame from underneath with
your fingers.
The T-2INSERT Kit Option (80-00006699)
You can install the T-2INSERT kit (which includes 1 pass-through insert and a blank insert)
instead of a power socket.
2. Raise or lower the connecting surface to the required height, insert the screws, and
tighten them in place.
KR A ME R EL ECT RON IC S L TD .
Installation
Instructions
MODEL:
T3F-1C
Inner Frame
For the latest information on our products and a list of Kramer
distributors, visit our Web site where updates to these installation
instructions may be found.
We welcome your questions, comments, and feedback.
Web site: www.kramerelectronics.com
E-mail: info@kramerel.com
SAFETY WARNING
Disconnect the unit from the power
supply before opening and servicing
P/N: 29 00-300065 Rev 3
P/N:
2900-300065
Rev:
3
!
Loading...