www.kramerAV.com
info@kramerel.com
Installation Instructions
MODEL:
T20F-64
Inner Frame
P/N:
29 00- 30 1466QS
Rev:
1
SAFETY WARNING
Disconnect the unit from the power supply before opening and servicing
For the latest information on our products and a list of Kramer distributors, visit our
Web site where updates to these installation instructions may be found.
We welcome your questions, comments, and feedback.
2
T20F-64 Inner Frame
T20F-64 Inner Frame
Congratulations on purchasing your Kramer T20F-64 Inner Frame for
TBUS-20XL(WAVES).
The T20F-64 inner frame includes:
• 2 openings for dual power sockets or Inserts (for example T-4INSERT).
• 2 openings for single power sockets or dual inserts (for example T-2INSERT).
• 4 pass-through inserts.
Power sockets, inserts, cables, and cable retractors are purchased
separately.
Go to www.kramerav.com/product/T20F-64 to check for up-to-date user
manuals and the complete list of Kramer wall plates and module connectors.
Figure 1: T20F-64 Inner Frame
Installation Instructions
3
Power Socket and Power Cord Options
Various power sockets and power cords are available to use with the T20F-64, as
described in the “TBUS Modular Power Socket Installation and Power Cord” Installation
Instructions, supplied with the power socket.
Mounting the Inserts
You can rearrange or remove any of the plates mounted on the inner frame and replace
them with Kramer passive wall plates or connector modules for interfacing A/V type signals.
To mount a Kramer insert or connector module:
1. Unscrew the two screws that fasten the pass-through insert to the inner frame and
remove it.
2. Place the required Kramer insert over the opening, insert the two screws to fix the
Kramer insert in place, and tighten them.
To insert the pass-through cables (for example, to connect to a laptop):
1. Remove the two screws that fasten the split pass-through bracket.
2. Remove the split grommet.
3. Insert the cable through the rectangular opening.
4. Open the split grommet slightly and insert the required cables.
5. Replace the split pass-through bracket.
Installing the Assembled Inner Frame
To install the T20F-64 inner frame:
1. Place the assembled inner frame inside the TBUS-20XL(WAVES) enclosure.
2. Set the required height using your fingers to bring the inner frame to the desired
position, screw and tighten it in place using the height adjustment screws supplied with
the inner frame.
Adjusting the Height of the Inner Frame
If needed, you can adjust the inner frame height to accommodate large or bulky cables.
To adjust inner frame height:
1. Remove the height adjustment screws, while supporting the frame from underneath
with your fingers.
2. Raise or lower the connecting surface to the required height, insert the screws, and
tighten them in place.
4
T20F-64 Inner Frame
Connecting the Cables
When replacing blank inserts with connector inserts (for example, VGA, audio, HDMI and
so on), insert the cables to their appropriate connectors from underneath.
After TBUS-20XL(WAVES) is connected to mains power and the proper cables, it is ready
to use.
Loading...