
Installation Instructions 
MODEL: 
RK-19N 
Under-the-table Brackets 
SAFETY WARNING 
Disconnect the unit from the power supply before opening and servicing 
For the latest information on our products and a list of Kramer distributors, visit our Web site where 
updates to this user manual may be found. 
We welcome your questions, comments, and feedback. 
www.kramerAV.com 
info@kramerel.com 

RK-19N Under-the-table Brackets 
The RK-19N consists of two 
metal brackets which are 
attached to the table via the six 
rim screw holes. 
Figure 1: RK-19N Under-the-table Brackets 
Congratulations on purchasing your Kramer metal RK-19N under-the-table brackets (one left 
bracket and one right bracket) for installing 1U machines underneath a wooden table or podium 
top. The RK-19N supports the following device types: 
 1U—for example, VP-732 or VP-773A  
 1/2-19" 1U (extrusion)—for example, PIP 4  
 1/3-19” 1U (extrusion)—for example, SL-10  
 1/4-19" 1U— for example, 907xl 
The RK-19N is sturdy, cost-effective and easy to install. 
Installing RK-19N 
To install the RK-19N: 
 Attach the RK-19N brackets to the sides of the Kramer machine  
 Fix the RK-19N with the machine under the table 
Attaching the Brackets 
You can attach the RK-19N brackets to all types of Kramer 19” 1U Kramer machines, as follows: 

1/4-19" 1U (extrusion) 
long 
Device Position and Screws 
19-inch (W), 7-inch (D) 1U 
(H)/Aluminum 
(four screws on each size - marked 
red) 

Device Position and Screws 
19-inch (W), 9-inch (D) 1U 
(H)/Aluminum 
(four screws on each size - marked 
red) 
19-inch (W), 7-inch (D) 1U 
(H)/Metal 
Two screws on each size - marked 
red) 
19-inch (W), 9-inch (D) 1U 
(H)/Metal 
Two screws on each size - marked 
red) 
Attaching the RK-19N under the Table 
1. Place the unit to the 
underside of the table and 
mark the correct location. 
2. Insert the six 4x16 wood 
screws into the six rim 
screw holes (three on each 
side) and fix the RK-19N to 
the table. 
Each bracket: 
4.4cm x 22cm x 5.7cm (1.7” x 8.7” x 2.2”) W , D, H 
Space between rim holes: 10cm (3.9”) 
0.35kg (0.8lbs) approx. (for the pair) 
Eight M3x8 screws; six 4x16 wood screws 
Specifications