
The Kramer Mounting Frame
The Kramer FLA-10 is a mounting structure that consists of the FLA-1F and the FLA-2F and is
used to install Kramer inserts to Ackermann Flush floor service units. The FLA-1F is a single
insert frame and the FLA-2F is a dual insert frame.
To install a Kramer insert, do the following:
1. Place and align the required wall plate insert item over the opening.
2. Insert the two screws to fix the insert in place, and tighten them.
To install the FLA-1F/FLA-2F insert, do the following:
The package includes the FLA-10 mounting structure, 2 sets of FLA-2F dual insert frames and
one FLA-1F single insert frame.
You can install up to 5 FLA-1F and/or FLA-2F in the Kramer FLA-10.
Figure 1: FLA-10
1. Place and align the FLA-1F/FLA-2F over the screw holes on the FLA-10.
2. Insert the two screws to fix the insert frame in place, and tighten them.
To install the FLA-10 inside the Ackermann Floor Box, do the following:
1. Run the cables through the Ackermann underfloor cable opening.
2. Connect the cables to the rear side of the inserts.
3. Fit the FLA10 tab into its designated place in the Ackermann underfloor box.
4. Place the tab with the slot into place in the Ackermann box and tighten the screw in place.
5. Connect the desired cables to the inserts.
Figure 2: FLA-1F
Figure 3: FLA-2F

Mounting Frame for Ackermann
Flush Floor Service Units
FLA-10, FLA-1F, FLA-2F
Installation Instructions
For the latest information on our products and a list of Kramer distributors, visit our
www.kramerelectronics.com Web site:
Kramer Electronics, Ltd.
Web site: www.kramerelectronics.com
E-mail: info@kramerel.com
P/N: 2900-000572 REV 1