Page 1
Corona Tag Quick Start
P/N:
2900- 301395QS
Rev:
4
Scan for full manual
Corona Tag Quick Start Guide
This guide helps you use your Corona Tag for the first time.
Go to www.kramerav.com/downloads/Corona Tag to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
Corona Tag
1 Neck Lanyard
1 Quick start guide
Step 2: Get to know your Corona Tag
Corona Tag is designed to keep your privacy:
• It records only if you are near another person’s Corona Tag.
• It does not collect your location.
• It collects only the minimum and relevant data.
• Corona Tag contains anonymous data.
• You have full control of your data:
▪ The collected data is stored in the Corona Tag itself.
▪ Only the Administrator has access to the stored data in your Corona Tag after transferring it to him/her.
▪ The data is located on premises and under its supervision and security practices.
• Using the Corona Tag is subject to your local privacy laws, the EU GDPR and the organization’s privacy and security
policies and practices.
• Administrator has full control of the data, including deleting it.
#
Feature
Function
1
LED
In normal operation mode, LED flashes briefly every 10 seconds.
Flashes RED when there is another Corona Tag nearby.
Flashes GREEN when there are no identifiable tags nearby.
2
Lanyard Buckle
To attach to lanyard.
3
Activation Button
To initially activate Corona Tag out-of-the-box.
For administrative purposes only. Only a
System Administrator has the required cable
to connect to the Corona Tag Management
System to identify contact with other tags.
4
Micro USB Type B
Connector
To connect to a PC with Corona Tag
Management System installed.
Page 2
Step 3: Using Corona Tag
Corona Tags require activation by the Corona Tag Management System software before use.
Upon receiving your Corona Tag, be sure it has been activated (flashing every 10 seconds). If not, contact your Administrator.
• Corona Tag eliminates the need for a company-wide shut down in case of infections.
• For the most accurate social distance monitoring, wear Corona Tag uncovered on the chest.
• Corona Tag hibernates after 30 minutes of inactivity and powers up immediately upon sensing motion.
• No charging or interaction required.
• Keep Corona Tag away from water.
• When Corona Tag battery falls below 5%, the LED flashes red continuously.
• If you test positive for Covid-19, contact your company’s Corona Tag Administrator immediately.
• To assure safety and health, Corona Tag is based on low power scanning, equivalent to 10% of the radiation
produced by a standard Bluetooth headset.
• Corona Tag does not contain any broadcasting or receiving devices other than Bluetooth.
• No employee information or location is stored (only encountered tag ID, tag distance, and date/time).
• It is advised to use Corona Tag in conjunction with local health authorities’ recommendations and guidelines.
• If an employee tests positive for Covid-19, only his Corona Tag is investigated to retrieve a list of encounters with
other Corona Tags.
• The Corona Tag battery lasts approximately 4 to 6 months (based on usage), and must be replaced by a technician.
Kramer Electronics, LTD. Corona Tags are not designed nor intended to prevent, mitigate, eliminate, treat, diagnose or cure any disease or
health condition including COVID-19/Coronavirus. Corona Tags are intended for public use only to monitor social distancing and provide for
contract tracing in the workplace, school and public venues. Kramer Electronics, LTD. specifically disclaims that Corona Tags will prevent
infection or the transmission of virus(es) or infectious disease(s), including but not limited to, COVID-19/Coronavirus.
Loading...