Kozy-World KPH120 Installation, Operation And Maintenance Manual

Kozy-World®

GAS-FIRED INFRARED

OUTDOOR SPACE HEATER

USER’S INSTALLATION, OPERATION AND

MAINTENANCE MANUAL

MODEL : KPH120 (PROPANE, 11,000 BTU/HR)

FOR YOUR SAFETY

If you smell gas :

1. Shut off gas to the appliance.

2. Extinguish any open flame.

3. If odor continues, immediately call your gas
supplier.

Ø INSTALLER : LEAVE THIS MANUALWITH THE CONSUMER
Ø CONSUMER : RETAIN THIS MANUAL FOR FUTURE REFERENCE

FOR YOUR SAFETY

Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other gas appliance.

WARNING! For outdoor use only.

TABLE OF CONTENTS

PAGE NO.

. General Safety Instructions 1
. Heater Assembly Instructions 2
. Self Contained Propane Systems 2
. Gas Supply Connection 3
. Locating Your Heater 3
. Clearance to Combustibles 3
. Lighting 3
. Shutdown & Storage Instructions 4
. Maintenance 4
. Main Burner Removal & Installation 4
. Test Firing Heater 5
. Alternate Gas Supply Systems 5
. Troubleshooting 6
. Parts List 7
. Warranty Information 8

CALIFORNIA PROPOSITION 65 -

WARNING

Fuels used in gas or oil-fired appliances and the
products of combustion of such fuels, contain
chemicals known to the State of California to
cause cancer, birth defects and other reproductive
harm. California Health & Safety Code Sec

25249.6

Improper installation, adjustment, alteration, ser­vice or maintenance can cause injury or property
damage. Read the installation, operating and
maintenance instructions thoroughly before
installing or servicing this equipment.

WARNING

IMPORTANT: Read this user’s manual carefully and completely before using. Serious injury or death

from burns, fire, explosion and/or carbon monoxide poisoning can result from improper
use.

IMPORTANT SAFETY PRECAUTIONS :

• Children and adults should be alert to high surface tem­perature around the burner assembly and heat reflector
when operating this heater.

• Children should be carefully supervised, when they are
in the area of the patio heater.

• Any cleaning agent used on the heater should be of a
non-corrosive and non-combustible type.

• The stainless steel emitter screen and gas valve normal­ly do not require cleaning and should never be painted.
The reflector and control cover may be cleaned but
never painted.

• Always maintain proper clearance from combustible
materials. Minimum clearance from combustibles :
Side 10”; Ceiling 12”; Rear 10”; and Below 30”.

• Heater must be placed on a level and secure surface and
shall be readily accessible.

• Never hang anything including clothes or other flamma­ble items on the heater.

• Do not operate this heater unless it is completely assem­bled with reflector and guard grill in place.

• Adequate clearance around air openings into the com­bustion chamber, provisions for accessibility and for
combustion and ventilation air supply must be main­tained at all times when the heater is operating.

• The heater should be inspected before initial use and at
least annually by a qualified person. More frequent
cleaning may be required as necessary. It is imperative
that the control compartment, burner and circulating air
passages of the heater be kept clean.

• Never connect heater to an unregulated gas supply.

• Propane cylinder must be disconnected when the heater
is not in use.

• Never refill disposable propane cylinders.

• Do not use in high winds or when lightening is present.

PRODUCT FEATURES

. Self Contained
. Lightweight and Moveable
. Integral/Positive Piezo Igniter
. Safety Tip-Over Shutoff System
. Uniformly Distributed Heat Pattern

UNPACKING :

1. Remove heater, reflector and guard grill from carton.

2. Remove all protective packaging applied to heater parts
for shipment.

3. Retain carton and packing material until heater is oper­ated and found in good condition.

• The heater is shipped from the factory for propane gas.
This heater is for use with propane gas only, do not con­vert heater to any other gas.

• A minimum supply pressure of 11” water column is
required for the purpose of input adjustment. Any
replacement regulator must be UL listed. The minimum
inlet pressure to the regulator from the gas tank is 5 psi
and maximum pressure is 150 psi.

• Do not move the heater while in operation. Always
allow heater to cool completely before moving.

• This heater is designed for heating purposes only and
should never be used for cooking.

• All gas connections should be checked for leaks utiliz­ing a soap solution. Never use a flame for gas leak
checks.

Check heater for any shipping damage. If
any of the parts show any external or internal
damage or if there is a part missing please
call 1-800-776-9425 for a free replacement.
DO NOT RETURN HEATER TO PLACE
OF PURCHASE.

1