Kool Tek FG8, G8 User Manual

User Manual

FG8 Hot and Cold Cooler

www.KoolTekCoolers.com

Please read the enclosed operating instructions carefully and retain this booklet for
future reference. We have carefully engineered your Water Dispenser to give you years
of enjoyment and trouble free operation.

IMPORTANT SAFEGUARDS

WARNING: Unit must remain in upright stationary position
for no less than 24 hours before operating.

• Never turn the dispenser upside down or tilt more than 45 degrees. If the unit has been
resting on its side for a long period of time, place the water dispenser in the upright
position for approximately 12 hours before turning it on.

• This water dispenser is equipped with a grounded power cord plug for your safety.

• Keep your water dispenser in a dry place away from direct sunlight.

• Never put anything ammable close to the dispenser.

• Leave a minimum of 2” (5 cm) around the back and sides of the dispenser for proper
ventilation.

• Always install your water dispenser on a level oor. Wait 3 minutes before restarting
machine after shutting it down. Always unplug the water dispenser before servicing.

• Regular cleaning of your water dispenser is required for your warranty.

• Please follow the cleaning instructions outlined in this manual and clean the dispenser
every 4 months.

GROUNDING INSTRUCTIONS

• Improper use of the grounding plug can result in a risk of electric shock causing serious
injury, even death.

• This appliance must be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electric shock by providing an escape wire for the electric current.

• This appliance is equipped with a power cord having a grounding wire with a grounding
plug and must be connected into a properly grounded polarized outlet. Consult a
qualied electrician if the grounding instructions are not completely understood, or
if doubt exists as to whether the appliance is properly grounded. If the wall outlet is
a standard 2 prong outlet, it is your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.

• Do not under any circumstances cut or remove the third (ground) prong from the
power cord plug. Do not use an adapter plug with this appliance.

• Do not use an extension cord with this appliance. If the power cord is too short, have a
qualied electrician install an electrical outlet near the appliance.

2 Kool Tek G8 Hot and Cold Water Cooler Manual

PLUMBING GUIDELINES

1. Make sure cooler is upright for at least an hour before installation. Ensure all pieces of
the cooler are attached properly.

2. Plug cooler into electrical outlet.

3. Make sure hot tank switch is in the OFF position.

4. Attach the 1/4” water line to the inlet port of the cooler.

5. Turn water on and wait 5 minutes to allow tanks to ll.

6. Once tanks have lled, test each faucet to ensure steady stream.

7. Turn on hot switch.

8. Check for leaks on all connections.

Kool Tek G8 Hot and Cold Water Cooler Manual 3