Kool Tek CG6 Tri Temp, FG6 Tri Temp User Manual
User Manual
FG6 Tri Temp Water Cooler
CG6 Tri Temp Water Cooler
www.KoolTekCoolers.com
FG6
CG6
Please read the enclosed operating instructions carefully and retain this booklet for
future reference. We have carefully engineered your Water Dispenser to give you years
of enjoyment and trouble free operation.
IMPORTANT SAFEGUARDS
WARNING: Unit must remain in upright stationary position
for no less than 24 hours before operating.
• Never turn the dispenser upside down or tilt more than 45 degrees. If the unit has been
resting on its side for a long period of time, place the water dispenser in the upright
position for approximately 24 hours before turning it on.
• This water dispenser is equipped with a grounded power cord plug for your safety.
• Keep your water dispenser in a dry place away from direct sunlight.
• Never put anything ammable close to the dispenser.
• Leave a minimum of 2” (5 cm) around the back and sides of the dispenser for proper
ventilation.
• Always install your water dispenser on a level oor. Wait 3 minutes before restarting
machine after shutting it down. Always unplug the water dispenser before servicing.
• Regular cleaning of your water dispenser is required for your warranty.
• Please follow the cleaning instructions outlined in this manual and clean the dispenser
every 4 months.
GROUNDING INSTRUCTIONS
• Improper use of the grounding plug can result in a risk of electric shock causing serious
injury, even death.
• This appliance must be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electric shock by providing an escape wire for the electric current.
• This appliance is equipped with a power cord having a grounding wire with a grounding
plug and must be connected into a properly grounded polarized outlet. Consult a
qualied electrician if the grounding instructions are not completely understood, or
if doubt exists as to whether the appliance is properly grounded. If the wall outlet is
a standard 2 prong outlet, it is your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
• Do not under any circumstances cut or remove the third (ground) prong from the
power cord plug. Do not use an adapter plug with this appliance.
• Do not use an extension cord with this appliance. If the power cord is too short, have a
qualied electrician install an electrical outlet near the appliance.
2 Kool Tek G6 Tri Temp Water Cooler Manual
CLEANING AND MAINTENANCE
Like most appliances, your water dispenser requires periodic maintenance for maximum eciency and performance and must be cleaned on a regular basis (i.e. every 4
months).
To maintain a hygienic environment within your water dispenser and prevent potential
formation (growth) of bacteria, we strongly recommend regular cleaning.
Cleaning the Outside of the Water Dispenser
The outside of the dispenser can be wiped clean with clean solution or a mild soap and
water mixture. Never use harsh chemicals or abrasive cleaners. Rinse thoroughly with
clean water and then dry surfaces.
Cleaning the Drip Tray
To remove the drip tray, (Fig. 8) pull the tray forward dislodging it from the guides. Drain
and clean.
The drip tray should be emptied and cleaned regularly to remove spotting and any mineral deposits. Clean with cleaning solution or a mild soap and water mixture. For tough
deposits, add vinegar and let it soak until the deposits come loose. Then wash, rinse
and dry thoroughly. To replace, put the grill back on the tray and slide the tray onto the
guides (not dishwasher safe).
Cleaning the Condenser
Vacuum or sweep away the dust from the condenser coils at the back of the dispenser.
For best results, you can purchase a brush designed specically for this purpose from
your local appliance store. This will improve cooling and eciency.
Draining the Reservoirs
Drain the reservoirs before and after cleaning, when going on long vacations or if not
using the dispenser for long periods of time.
IMPORTANT! Unplug the dispenser before performing this procedure.
Dispense hot water until temperature drops to a safe level to avoid the risk of scalding.
1. Press all 3 dispense buttons until water no longer comes out
2. Place a bucket beneath the drain valve on the back of the dispenser
3. Remove the cap and plug from the drain valve and let the water ow into the bucket
4. Replace the cap and plug
IMPORTANT: Collect the water in a container, not the drip tray.
Going Away on Vacation
When not using the dispenser for long periods of time or when going on vacation, conserve energy, unplug the dispenser and drain the reservoirs (see Draining the Reservoirs). Follow Initial Product Cleaning Procedures upon return and startup of the dispenser.
Kool Tek G6 Tri Temp Water Cooler Manual 7
Loading...