KOOGEEK BA Quick Start Manual

Koogeek

Bedwetting Alarm

BA

Quick Start Guide

1. Working principle and application scope

The product uses the resistance impedance to measure the temperature, and uses the
thermistor to measure the temperature. The MCU would calculate the current temperature and
humidity through the peripheral circuit, and monitor if a bedwetting incident occurs by
comparing with the threshold.
This product is mainly suitable for home use.

Safety precautions

• To prevent children from playing with the product, p arent s are advised to wear the product for
the child after he/she fall asleep.

• Make sure that the probe and probe clip does not come in direct touch with the skin. Sweat
on the skin may cause an alarm.

• Pay attention to the operating temperature and humidity requirements of the product.
Measurement errors may occur if it is used in an environment that does not meet the
requirements.

Warning

Do not place the battery where infants and young children can reach out.
Do not put the battery into the fire, or it will cause an explosion.
Do not sterilize or autoclave.
If there is any damage to the probe, stop using the product immediately.

How to use the Koogeek app

1. Scan the QR code on the package box to download the Koogeek app.

2. Visit the website to download the app http://app.koogeek.com/download

3. Search "Koogeek" and download the app on a third-party application platform (e.g. App
Store / Google Play).

4. Install the Koogeek app. If you are a first-time user, you need to sign up for an account (Note:
One registered account supports multiple users).

5. Turn on the Bluetooth function when using the Koogee k app. (You need to launch the
Koogeek app before connecting to the Koogeek devices).

6. Add new users: "Main Menu" > "Setting" > "Add new users"

7. Switch the unit: "Main Menu" > "Setting" > "Unit"

8. Unknown measurements: Sometimes Koogeek devices cannot identify the corresponding
users of the measurement data. The dat a will be uploaded to the app via Bluetooth and
displayed in the "Unknown measurements". You can check the "Unknown measurements" and
assign the data to the specified users.

Installation and setup

1. Remove the insulation tag from the battery compartment.

2. Power on: Press and hold the "+" button about 3 seconds. The blue indicator will be on for 3
seconds. The indicator flashes green when Bluetooth is not connected. The indicator flashes
blue when Bluetooth is connected.

3. Power off: Press and hold the "-" button about 3 seconds. The green indicator on the device
will be on for 3 seconds and then goes off.

4. Automatically connect via Bluetooth: After you turn on Bluetooth on your phone and open
the Koogeek app, it will automatically connect to the app via Bluetooth when you power on the
product. No need to enter the Bluetooth connection password.

5. Install the product: Use the magnetic button to attach the alarm to your child's pyjama top or
a dry place by the bed side. Clip the probe onto your child's nappy or underwear, in the place
most likely to get wet first.

6. Change the alert settings: Open the app, turn on Bluetooth, pair with this pro duct, and select
alarm tone, volume level and vibration.