Konwin PHW-1500 Technical Description And Operating Instructions

INFRARED HEATER

Model: PHW-1500

TECHNICAL DESCRIPTION

AND OPERATING MANUAL

ATTENTION!

SWITCH ON THE HEATER IN FULLY HORIZONTAL POSITION!

DO NOT COVER!

TABLE OF CONTENTS

Issue 1. Acquaintance to the heater

Issue 3. Technical feature

Issue 3. Installation

Issue 4. Usage

Issue 5. Maintenance

Issue 6. Attention

ISSUE 1: ACQUAINTANCE TO THE HEATER

\\

ISSUE 2: TECHNICAL FEATURE

Model: PHW-1500

Voltage

120V~

Frequency

60Hz

Electric power(W)

1500W

1

Switch

2

Heating element

3

Bracket

4

Cable

5

Safety bar

6

Hoods

ISSUE 3: INSTALLATION

How to connect with stents products

①Productfeet frame diagram

1

Foot bottom

2

Fixing nut

3

Large washer

4

Products connecting bolts

5

Positioning sleeve

②With screw through screw holes and product

connection is fixed to the holder

The product is connected in stents

ISSUE 4: MAIN RULES OF HEATER USING

Install the heater strict in horizontal position i.e.

PARALLEL TO FLOOR

Direct the heater the APPROPRIATE ANGLE
Prevent the lost of directed heat through the windows.

Avoid the placing of foreign objects on the safety bar.
Don not cover!
Before motion the heater be sure that the power supply is switched off.
Attentively adjust the position of the thermostat in dependence of the
heated square.
Commentary: In the position of the thermostat at the high the heater will

be working constantly.
It is recommended to install the thermostat at the high mode spaces
in the large rooms or on the opened
places.

The heater will be power off when thermostat is in the low position.

It can be dangerous to install near curtains and other combustible materials.
Do not use the power lines to bundle the Electric Radiator, or it will damage the
Insulation coat of the power lines.
If the power lines are damaged, not to continue to use them, in order to avoid
Some danger, and they must be replaced by the factory or the maintenance

Department of the factory or the other similar professional staff.

IF YOU WANT TO INTEGRATE TWO OR MORE HEATERS INTO
INTEGRATED
HEATING SYSTEM ASK THE AUTHORIZED SERVICE CENTERS TO
INSTALL.

ISSUE 5: MAINTENANCE OF THE HEATER

It is necessary to wipe periodically the heater and the reflector, depending on the
Place and the circumstances of its use.
Cleaning of the reflector:

① Disconnect the cable of power supply

from the socket.

②Take off the heater body the safety bar.（Figure l6.1,16.2,16.3）

③Wipe the reflector by the soft cloth, treated by detergent, frying not to

leave on the surface the tinged prints and spots.

Commentary：Do not use the detergents which are able to damage the reflector.
Wiping has to be done very careful without any scratches.

Be sure the heater has not these faultiness：

1. Check whether the thermostat can be switched on or off．

2. Check whether the heater is connected rightly the electric wiring．

3. Check the intactness of electric wiring.

ISSUE 6: ATTENTION TO R THE CONTENT

Warning:

1. Read the instructions carefully before use and save them for future reference.

2. Always disconnect the heater from the main supply when not in use and when
cleaning.

3. Do not leave the heater“ON”unattended.

4. In order to avoid over heating, do not cover the heater.

5. Keep the heater a distance of at least 100 cm from any combustible material, such
as furniture, curtains, bedding cloths or papers.

6. Keep the heater clean. Do not allow objects to enter the ventilation，as this may
cause electric shock, fire or damage the heater.

7. Close supervision is required when any appliance is used near or by children.

8. Never allow the cord to touch wet or hot surfaces, become twisted or be within
the reach of children.

9. Can use outdoor.

10. Do not place on or near a hot gas or electric burner.

11. Remove the packing and make sure that the appliance is intact. In case of
doubt do not use the appliance and contact our after-sales service. Do not leave
Packaging materials like bags and staples within reach of children.

12. The use of every electrical appliance calls for the awareness of some basic
rules, such as:

- Never touch the appliance with wet or damp hands or feet

- Never expose the appliance to atmospheric conditions(rain,sun,etc)

13. Do not use the appliance for anything other than its intended use.

14. This appliance is intended for household use only.

15. Do not use this heater in the immediate surroundings of a bath, a shower or
a swimming pool.

16. Any repairs that need to be done to the heater must be referred to an
authorized service agent only.

17. Do not put the cable on the appliance when it is still warm.

18. Do not damage and do not kink the power cord.

19. Do not connect the appliance to extension cords or multiple outlets.

20. In case the power cord is damaged send it to the nearest after sale service
Recommended by the manufacturer for the replacement.

21. The fireguard of this heater is intended to prevent direct access to heating
elements and must be in place when the heater is in use; The fireguard does not
give full protection for young children and for infirm persons.

22. This heater is not equipped with a device to control the room temperature.
Do not use this heater in small rooms when they are occupied by persons not
Capable of leaving the room on their own, unless constant supervision is provided.

23. The appliance is not intended for use by persons(including children)with
Reduced physical, sensory or mental capabilities, or lack of experience and
Knowledge, unless they have been given supervision or instruction concerning
Use of the appliance by a person responsible for their safety.

24. Children should be supervised to ensure that they do not play with the
appliance.

25. The heater must not be located immediately below a socket-outlet.

Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.