Konka Group Baby Talk GPS User Manual
Baby Talk GPS Child Tracker
User Manual
Baby Talk GPS Child Tracker User Manual Page 2
Introduction
1. Please check the accessories according to the list aer purchasing the phone.
2. is product has some special functions for you and your child, please read this guide carefully
about these functions.
3. Please make sure the calling number display function is available.
4. Please tell your child to have a call through the loudspeaker as possible as he can.
Accessories List
• User guide
• Main unit
• Li-Battery
• Charger
• Data line
Status Bar
Baby Talk GPS Child Tracker User Manual Page 3
Install the SIM Card and Battery
NOTE: SIM card is not included. Purchase from any carrier, including “Pay As You Go” SIM card. Please consult
with the dealer about the service and usage of the SIM card.
Please turn o the unit and disconnect the unit with the charger and other accessories before moving away the
battery cover.
1. Turn o the unit, move away the battery cover and take out the battery. en insert the SIM card as shown in
the illustration.
Please refer to the pictures about the structure of the SIM card holder and follow the below steps to insert the SIM
card: Slide down the SIM card cover to separate from the port. Li the SIM card cover and insert the SIM card.
2. Please insert the battery as shown in the illustrations. Please make sure the unit is turned o before moving
away the battery cover and disconnecting with the charger and other accessories. Make sure the battery cover
is well installed during use the phone.
Baby Talk GPS Child Tracker User Manual Page 4
Turning the Unit ON/OFF
1. Hold the multifunctional key about 3 seconds to turn on the unit.
2. Hold the multifunctional key about 3 seconds to turn o the unit.
Keyboard
Keyboard Functions
➢ Hold 3 seconds to turn on/o the phone.
Multifunctional key
➢ Reject the calling/end a call.
➢ Enter the main menu from idle screen.
Hotkey 1-4
Emergency calling
key
➢ In any layout, hold each key to call the corresponding family numbers in [Contacts].
➢ Scroll menu and text.
➢ In any conditions, hold this key to call the SOS number and the family number in
[Contacts] in turn, until one of the callings is answered, and it will send an SOS
message to binded guardian phones.
Quick Start
1. Please insert the SIM card and the battery to the child phone, and then hold the multifunctional key about 3
seconds to turn on the unit.
2. Use any mobile phone to edit and send the command message- “Bind guardian numbers” to the child phone.It
is very important to set the guardian numbers, since only the binded the numbers can send command message
to the child phone.
e format of “Bind guardian numbers” command message:
Bind one guardian number: bind#numberA
Bind two guardian numbers: bind# numberA#numberB
3. If the message is successfully sent, the child phone pops up a window and require the guardian to enter the
privacy code to conrm the setting of binding numbers. e default privacy code is to press “Up, Up, Up,
down, down, down” hotkey.
NOTE: If you want to reset the binded number, please resetting the binded number at rst.Select [Settings] –
[Phone setting] – [Parent setting], then input the privacy pwd and select [reset binding] to clear the setting.
en you can send the command message to binded again.
Aer binding the number, guardians can edit and send other command messages to the child phone by using
the binded number.
Baby Talk GPS Child Tracker User Manual Page 5
Commands
e guardian’s phone can send commands to change the child phone’s settings.
e message format for commands :
COMMAND THE MESSAGE FORMAT EXAMPLE EXPECTED RESULT
The binded guardian phone
can send command message
to the child phone and receive
specific-formatted message
about the child phone.
Bind guardian
numbers
Remote power off poweroff#
Startup monitor monitor#
A child number can be binded
with two guardian numbers at
most.
Bind one guardian number:
bind#numberA
Bind two guardian numbers:
bind# numberA#numberB
• Bind one number:
bind#15047804504
• Bind two numbers:
bind#15047846032#
18847161549
After sending the command, the
guardian should enter the privacy
code on the child phone to confirm.
The default privacy code is to press
“Up, Up, Up, down, down, down”
hotkey.
Guardians can check the binded
number in the [Settings]-[Binding
Status]
The child phone will power off
automatically.
The child phone will automatically
dial the guardian phone which sends
the command without changing the
interface. When the guardian answers
the phone, they can hear the sound
from the child phone while the child
phone can’t hear from the guardian
phone.
gpsposition#
Remote position
with GPS inquiry
Set fence
The guardians can send this
message to check the current
position of the child.
gpsposition#fence name
Set the child phone’s current
position as the center of the
circular fence with the radius
of 1 km, fenced off by default.
5 fence at most.
When fence is activated, once
the children get into/out of the
fence, alarm information will
be sent to the guardian phone.
• Set a fence named
“School”:
gpspostion#School
This fence named
with “School”, stores
the current location
of the child phone as
the center and has a
radius of 1km.
The guardian phone can receive
the SMS about thelocation of the
child phone. The specific content of
the message please refers to the
instructions [How to Search The child
position].
Guardians can check the detail of the
fence in [Settings]-[Parent Setting][StoredLocations].
Loading...