Konig Infrared remote control extender User Manual

IR-EGGS2

REMOTE CONTROL
EXTENDER

LOCATION OF CONTROLS

Transmitter Side

DC Power

Transmitter and

Receiver Front

Accessory

Infrared Remote
Control Antenna

Remote Control
Indicators &
IR Transmitter/Receiver

DC 12 V
AC 220V or 240V
Adaptor x2

Receiver Side

IR Probe

DC Power

Infrared
Extender X 1

CAUTION:

This equipment has been tested and found to comply with CE
regulation. These regulations are designed to provide reasonable
protection against harmful inter-ference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with this manual,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular situation. If this equipment does cause harmful interferen
ce to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna
Increase the distance between the interfered equipment and the
receiver
Connect the interfered equipment into an outlet on a circuit
which is different from that the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.

IMPORTANT SAFETY PRECAUTIONS

To prevent fire or shock hazard, do not submerge or expose this
products to water

To avoid electric shock, do not open this units. The IR-EGGS2
contains no user serviceable parts. Doing so will void the
warranty

Use only the power supply provided with the

Do not overload wall outlets or extension cords.

If you are experiencing difficulty with this products, do not
attempt to service it yourself. Please call your vendor for
assistance.

IR-EGGS2