![](/html/4d/4dac/4dac32fec2a7e866382dcaff415b04991f485d03b64e8585d294c1bd6b45275a/bg1.png)
-1-
Quick Installation Guide
(please refer to the full English manual on CD for specifi c details)
1. Package contents
1 Internet Camera
1 Power Adapter
1 Camera Stand
1 Cat5 Ethernet Cable
1 Quick Installation Guide
1 CD
1 Antenna
2. System requirements
Windows 98, ME, 2000, XP + SP2, Server 2003, Vista
Intel Pentium III 750MHz above or Intel Celeron 1GHz above
Memory: 128MB (256MB recommended)
VGA Card Resolution: 800 x 600 or above
3. Hardware installation
3.1 LED and Focusing
The camera focus ring allows you to modify the focus of the Camera. To adjust the camera’s focus,
rotate the dark focus ring.
There are four LEDs indicating the camera status and networking status.
Monitoring
When a user is viewing the camera, the LED will be on.
Ready
When the camera is powered on and ready for use, the LED will be on.
LAN
When the camera is linking to the wired network, the LED is on. The LED will be fl ashing when
video is transmitted or received through the wired network.
WLAN (only for CMP-NWIPCAM30)
When the camera is linking to the wireless network, the LED is on. The LED is fl ashing when video
is transmitted or received through the wireless network.
IP NETWORK CAMERA
CMP-NWIPCAM20
CMP-NWIPCAM30
ENGLISH
INSTRUCTIONS
![](/html/4d/4dac/4dac32fec2a7e866382dcaff415b04991f485d03b64e8585d294c1bd6b45275a/bg2.png)
EN
-2-
3.2 Camera Ports
The camera features three ports and a reset button.
Antenna
Standard port with reverse SMA connector.
Power
Connection for power adapter.
LAN
Connection for Ethernet network cable.
Reset button
1. If a problem occurs with your camera, press the reset button with a pencil tip (for less
than 2 seconds) and the camera will reboot itself with your confi guration.
2. If the problem persists or you experience extreme problems or you forgot your
password, press the reset button for longer than 5 seconds. The camera will reset
itself to the factory default settings (warning: your original confi gurations will be
replaced with the factory default settings).
4. Installation Procedure
- Connect the camera to your network with the attached the network cable from the switch/router
to the LAN port of the camera.
- Connect the power adapter to the camera and plug the power adapter to a power outlet. The
camera will be powered on. When the camera is ready, the Ready LED will be on.
5. Software Installation
Follow the steps below to run the Install Wizard to guide you quickly through the Installation process.
The following installation is implemented in Windows XP. The installation procedures in Windows
2000/XP/Server 2003 are similar.
Insert the CD shipped along with the camera into your CD-ROM drive. The “Autorun.exe” program
should be executed automatically. If not, run “Autorun.exe” manually from “Autorun” folder in the
CD.
![](/html/4d/4dac/4dac32fec2a7e866382dcaff415b04991f485d03b64e8585d294c1bd6b45275a/bg3.png)
EN
-3-
The Install Wizard will show four selections, select the program you want to install or click “Exit”
to install the program later. The following installation steps are the demonstration of “Install
Administrator Utility & Camera Viewer”.
The system will start the installation procedures. Click “Next” to continue installation.
If you wish to install the software program in an alternate location, click “Change”; otherwise click
“Next” to move on to the next step.