Printed in Japan9242-4886-41
©2002 KONICA MINOLTA SENSING, INC.
7
Forcorrect use and for your safety,be sure to read the instruction
manual before usingthe instrument.
• Alwaysconnectthe instrument tothe specifiedpower supply
voltage.Improperconnectionmay causea fire orelectricshock.
• Be sure to use the specified batteries.Using improper batteries
may causea fire or electricshock.
3-91, Daisennishimachi, Sakaiku, Sakai, Osaka 590-8551, Japan
Konica Minolta (CHINA) Investment Ltd. SE Sales Division
Rm.29A,K Cross Region Plaza, No.899 Lingling Rd., Shanghai, China
Phone: +86-021-5489 0202 FAX: +86-021-5489 0005
Konica Minolta Sensing Singapore Pte Ltd.
10, Teban Gardens Crescent, Singapore 608923
Phone:
+65 6563-5533
FAX:
+65 6560-9721
Addresses and telephone/fax numbers are subject to change without notice. For the latest contact
information, please refer to the KONICAMINOLTA SENSING Worldwide Offices web page (link below).
SAFETY PRECAUTIONS
http://konicaminolta.com/about/se/contact.html
Main Specifications
Measuring method: Determines yellowness of subcutaneous
tis-sue by using two optical paths to
measure optical density difference at two
wavelengths
M easuring range: 0.0~25.0 mg/dL or 0~425 µmol/L
A ccuracy (σ):
±
1.5 mg/dL or±25.5µmol/L
D isplay: LCD(back light)
Figure: 3 figures
Unit: mg/dL, µmol/L(changeable)
Battery mark
Ready lamp: green LED lit
Ligh t source: Pulse xenon arc lamp
Ligh t source life: 150,000 measurements
S ensors: Silicon photodiodes
P ower source: Special Ni-MH battery
P rotection type Internally powered instrument, BF type
and le vel:
P ossible number of At least 400 measurements when fully
M easurements: charged
Operating temperature
/ 10 to 40°C, relative humidity 30 to 95% or
humidity range: less with no condensation
S torage temperature/
-10 to 50°C, relative humidity 30 to 95%
humidit y range: or less with no condensation
D imensions: 48mm(W )×154mm(H)×32mm(D)
W eight: 150g(including Ni-MH battery)
O ther function: Averaging function
Standard accessories:Charger Unit (with a built-in checker)
AC Adapter,Strap,Soft Case
Charger Unit
(with a built-in checker)
Fig.1
Fig.2
T he Jaundice Meter JM-103 determines the yellowness of the sub-cutaneous tissue of a newborn infant by measuring the difference in optical
densities for light in the blue (450 nm) and green (550 nm) wavelength regions.The measuring probe has two optical paths (see Fig. 1). The use of
this method allows measurement of yellow-ness of the skin and subcutaneous of a newborn infant with the in-fluences of melanin pigment and
skin maturity kept at a minimum, which was impossible with conventional methods.
When the measuring probe is
pressed against the forehead or ster-
num of the infant, the built-in
xenon lamp flashes, and the light
from the xenon lamp is guided to
the skin surface through the glass
fiber and illuminates the skin. The
light is then scattered and absorbed
in the skin repeatedly, and finally
returns to the glass fiber (sensor
side). Of the light that returns to the
fiber, the part scattered from
shallow areas of the subcutaneous
tissue passes through the inner
core (short optical path) of the fiber
while the part scattered from deep
areas of the subcutaneous tissue
passes through the outer core (long
optical path), and then they reach
their corresponding photodiode.
By calculating the difference in optical densities, the parts that are
common to the epidermis and dermis will be deducted, and as a re-
sult the difference in optical densities between the two wavelength
regions can be obtained for the subcutaneous tissue only.
Since the optical density difference shows a linear correlation with
serum bilirubin concentration, it is converted to serum bilirubin
con-centration and indicated digitally.
Principle
2-wavelength photodiode
2-wavelength
photodiode
Sensor for short
optical path
Sensor for long
optical path
Diffuser panel
Diffuser panel
Long optical path
Light-emitting path
Short optical path
Glass fiber
Xenon lamp
Long optical path
Subcutaneous tissue
Epidermis
Dermis
Mature baby
Premature baby
Long optical path
Short optical path
Short optical path