Page 1
Kompernaß GmbH · Burgstrasse 21 · D-44867 Bochum
www.kompernass.com
ID-Nr.: KH4420-08/05-V2
UK
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 1
Page 2
Cordless Hand Vacuum Cleaner KH 4420
Operating instructions
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 2
Page 3
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 3
Page 4
102 mm
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 4
Page 5
- 3 -
KH4420
Cordless Hand Vacuum Cleaner KH 4420
Intended Usage 4
Delivery Contents 4
Technical Data 4
Important Safety Instructions 4
Before the First Use 6
Charging 6
Mounting the Wall Bracket 6
Assembly 7
Operation 7
Cleaning 7
Disposal 8
Warranty & Customer Service 8
Read the operating instructions carefully before using the appliance for the first time
and preserve this booklet for later reference. Pass the manual on to whomsoever
might acquire the appliance at a later date.
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 3
Page 6
- 4 -
Cordless Hand Vacuum
Cleaner KH 4420
Intended Usage
This hand vacuum cleaner may only be
used for the vacuuming of dry surfaces
and dry materials. People or animals may
not be vacuumed with this appliance.
Any other usage or changes to the
appliance are improper use and may
result in considerable danger of injury.
The manufacturer accepts no liability for
damages that result from improper use
of the appliance or are caused by incorrect operation of it.
The appliance is not intended for
commercial use.
Delivery Contents
Crevice nozzle
Dust collector
Dust filter
Motor unit
ON/OFF switch
Charge indicator light
Charging station / wall bracket
Screws / plugs for wall installation
Power adapter
NOTE: The cordless hand vacuum
cleaner model KH 4420 is delivered
with uncharged batteries. The batteries must be charged for 24 hours
before the first use.
Technical Data
Power adapter
Input voltage: 230 V ~ 50 Hz
Output voltage: Direct current (DC),
9 V / 150 mA
Batteries: 3 x 1,2 V Ni-MH
batteries /2200 mAh
Important Safety Instructions
To avoid a life-threatening electric
shock:
• Do not charge or use the appliance
outdoors.
• Never use the hand vacuum cleaner if
the cable, plug or casing are damaged.
• Send defective appliances to the
appropriate service centre or have
repairs performed only by a qualified
workshop. Under no circumstances
should you open the appliance yourself. Manipulations made by persons
other than qualified technicians could
represent a health hazard.
• Before switching the hand vacuum
cleaner on, make certain that the
mains voltage corresponds to the
voltage indicated in the technical
data for the appliance.
• Never touch the power supply or the
appliance with wet or damp hands.
• Do not use the power adapter with
an extension cord; connect the power
adapter directly to a power socket.
• Do not use the hand vacuum cleaner
for vacuuming up liquids.
KH4420
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 4
Page 7
- 5 -
To avoid the risk of injury:
• Do not change any accessories while
the appliance is switched on.
• Do not use the hand vacuum cleaner
for vacuuming up sharp objects or
glass shards.
• Never vacuum up burning matches,
glowing ashes or cigarette butts.
• Do not use the hand vacuum cleaner
for vacuuming up chemical products,
stone dust, gypsum, cement or similar
particles.
• This hand vacuum cleaner is only
suitable for use on dry surfaces. The
appliance is not suitable for foam,
water, flammable and explosive
substances or other liquids.
• Always store the appliance indoors.
To prevent accidents, keep the
appliance in a dry location when
not in use.
• Under extreme conditions, leaks in
the battery cells may occur. In the
event that battery fluid comes into
contact with skin or eyes, the affected
area must be rinsed off with water
immediately. Contact a physician.
To conduct yourself safely:
• Caution! Keep the power cord and
appliance away from children.
Children frequently underestimate
the danger from electrical appliances.
• Use only accessory parts recommended by the manufacturer.
• The cable of the charging station may
not be used for other purposes. Never
carry the charging station or the power adapter by the cable. Do not pull
on the cable when you want to move
the appliance.
• Always grip the power plug to disconnect the appliance from the power
supply.
• Always be sure to keep the hand
vacuum cleaner away from heating
elements, ovens or other heated appliances and surfaces.
• Always make certain that the ventilation slits are open. A blocked ventilation circuit can result in overheating
and damage to the appliance.
• This product contains rechargeable
Ni-MH batteries. Do not thow the
batteries into a fire and do not
subject them to high temperatures.
There is a risk of explosion!
• Take special care when using the
hand vacuum cleaner on stairs.
• Do not use the hand vacuum cleaner
without the dust filter inserted.
• Do not use the power adapter for a
different product and do not attempt
to charge this appliance with a different charging station. Only use the
charging station supplied with this
appliance.
KH4420
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 5
Page 8
- 6 -
Before the First Use
1. The cordless hand vacuum cleaner is
powered by rechargeable Ni-MH batteries. Before using the cordless hand
vacuum cleaner for the first time, the
batteries must be charged for at least
24 hours.
2. The batteries reach their full capacity
after a charging time of 24 hours. The
cordless hand vacuum cleaner can be
used for its full operating time when
the batteries are fully charged. Only
place the appliance back in the charging station once the vacuum po-
wer becomes noticeably weaker.
Charging
1. Insert the round plug of the power
supply into the back of the charging
station . Lock the plug by turning it
anti-clockwise.
2. Place the charging station next to
a power socket and plug the power
adapter in.
The charging station can optionally
be mounted on a wall with the supplied screws and plugs (see Chapter
„Mounting the wall bracket“).
Vertical screw spacing 102 mm,
screw diameter 3,5 mm.
You can insert the nozzle attachment
into the socket on the charging
station to store it.
3. Place the hand vacuum cleaner in
the charging station .The charge
indicator light lights up red and
the charging process begins.
NOTE: Make certain that the on/off
switch is in position "0" before
starting the charging process.
Important:
• Once the charging process is completed, the appliance automatically switches to the charge maintenance function. However, in order to avoid possible damage to the batteries, do not
leave the appliance constantly connected to the charging station .
• Only place the appliance back on the
charging station once the vacuum
power becomes noticeably weaker.
Important information about the
battery
In the event of a defective battery,
please contact our service centre directly. Please refer to the guarantee
card for the Authorized Service Outlet
in your country.
Mounting the Wall Bracket
1. Bore two holes with a spacing of
ca. 102 mm. Using the wall bracket
to mark the boreholes ensures the
correct spacing.
2. Push the plugs into the boreholes
and screw in the lower screw until
ca. 3mm is protruding.
3. Place the wall bracket on the lower
screw.
4. Guide the upper screw through the
wall bracket and into the borehole,
then screw it in.
5. Tighten both screws down.
KH4420
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 6
Page 9
- 7 -
Assembly
NOTE: Make certain that the dust
filter is always inserted before
using the appliance.
1. To open the dust collector , turn the
dust collector clockwise and pull it
off the motor unit .
Make certain that the dust filter is
inserted and put the dust collector
back on. Turn the dust collector
anti-clockwise until the arrow symbol
points to the dot on the motor
unit .
2. If the nozzle attachment is required, insert this into the suction
opening on the dust collector .
Operation
1. Remove the hand vacuum cleaner
from the charging station . Using
the supplied plugs and screws the
charging station can optionally be
mounted on the wall.
2. To switch the appliance on, move the
on/off switch to the position "I".
3. After use place the on/off switch
into position “O“.
4. The nozzle attachment is used to
clean narrow, hard-to-reach areas.
Put the assembled hand vacuum clea-
ner in the charging station and
start the charging process when the
vacuum power is noticeably weaker.
Cleaning
Changing and cleaning the dust filter
To achieve the best results, empty the
dust collector and clean the dust
filter after every use.
1. To open the dust collector , turn the
dust collector clockwise and pull it
off the motor unit .
2. To remove the dust filter from the
motor unit, turn it clockwise and pull
it off the motor unit .
3. Empty the dust collector .
4. Clean the dust filter in cold water
and wait until it is completely dry before putting it back on the motor unit .
5. Place the dust filter on the motor
unit . Turn the dust filter anticlockwise to attach it. Never use the
hand vacuum cleaner without the
dust filter inserted.
6. Put the dust collector back on.
Turn the dust collector anti-clokkwise until the arrow symbol points
to the dot on the motor unit .
Important! The suction opening
must always be open and unblocked.
Blockages lead to overheating and
damage to the motor.
KH4420
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 7
Page 10
- 8 -
Disposal
Disposing of the batteries
The hand vacuum cleaner is operated
with rechargeable Ni-MH batteries
that must be disposed of properly.
Put the old batteries into your local
recycling system. Follow the laws and
regulations for disposal that apply in
your country.
Disposal of the appliance
Do not dispose of the appliance
in your normal domestic waste.
Dispose of the appliance through an
approved disposal company or your
community waste facility.
Observe the currently applicable regulations. In case of doubt, contact your
waste disposal facility.
Warranty & Customer Service
You can find the service centre for your
country listed on the warranty card.
Kompernaß GmbH
Burgstrasse 21
D-44867 Bochum
www.kompernass.com
KH4420
KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 8
Loading...