• Before you start using your Contact grill,
please read the following directions for
use carefully.
• Keep this instructions brochure in a safe
place near the appliance for ready reference. Pass it on, as the case may be, to
the next owner of the appliance.
• Use the Contact grill only for its intended
purpose in accordance with the instructions given here.
Prevent electrical
shock hazards
•You may use the Contact Grill only indoors in a dry place. Keep the appliance
away from splashing water even when it
is switched off.
• Use the appliance only if the local power
supply voltage corresponds to the voltage specified for the appliance
(230 V AC at 50 Hz).
• Do not connect the appliance over a
multisocket adapter, from which many
other electrical devices may be simultaneously drawing power, as this can lead
to overloading of the circuit.
• After each use switch off the appliance
and unplug the unit.
• While cleaning, make sure that water
does not seep into the inner areas of the
appliance. Never attempt to clean the
appliance under running water. Never dip
the appliance into water.
•Protect the power cord from damages
through entanglement with other objects.
Keep it away from hot surfaces. Do not
let the power cord hang loosely from the
table or over the hot plate.
• Never open the housing of the appliance.
• Never use the appliance if the power
cord or the plug is damaged or wet. In
such an event, it may be necessary to
repair the appliance.
• Only service centres authorised by the
manufacturer or experienced technicians
may undertake repairs (see "Repair &
Customer Service").
4
Prevent fire hazards
and injuries
Before you use the appliance for
the first time
• Place your Contact Grill on an even,
nonslippery and heat-resistant base and
never on or near other appliances that
may radiate high levels of heat
(e.g. toaster or cooking-range).
• Do not operate the appliance near
inflammable objects, for example,
close to curtains or near tissue paper
roles in the kitchen.
• Even during general use, some of the
components of the appliance become
very hot (e.g. the top and bottom housing plates). Do not touch the surface
immediately after switching off the appliance until it cools down completely.
•To prevent possible overheating,
always unwind the power cord in
its entire length.
• While operating, you can open or close
the Contact Grill safely using the heatinsulated handle.
• Never operate the appliance without proper supervision. Provide supervision, if
children or frail individuals are allowed to
operate the appliance.
• After use, allow the appliance to cool
down completely before you clean and
store it away.
Prevent damages to
the appliance
• Use a plastic or wooden spatula or any
other suitable non-metallic utensil to
remove the food items so as not to
damage the non-stick coating of the
Contact Grill's hot plate.
• For the same reason, do not use any
corrosive detergents or pointed instruments when cleaning the appliance.
1. Unpack your new Contact Grill and
remove all extra fittings such as plastic
wrappers and cable clamps meant for
protection during transportation.
2. Read the directions for use carefully.
3. Install the appliance as described in the
safety precautions.
4. Clean the new Contact Grill with a wet
cloth as described under "Cleaning &
Maintenance".
When using the Contact Grill for the
first time, you may notice fumes
caused by heating. These fumes are
not injurious to health; however,
initially they may affect the taste of
your first few dishes.
Therefore, before preparing any food
items for the first time, we advise you
to switch on the Contact Grill once
without any food items and allow it to
heat up at the maximum temperature
setting for 15 minutes.
Description of the appliance
Pilot light
Snap locking device on the handle
Handles
Swivelling support
Temperature control knob
Hot plate locking springs
Ridge for oil drainage
Leads for fixing the hotplates
Grill hot plates
5
Roasting with the Contact Grill
1. Open the lid of the Contact Grill by
pulling the locking clasp on handle ,
downwards and tilt the lid up to the
stopper. If necessary, remove all fallen
food particles from the hot plate surface
using a dry cloth.
2. Dab some oil or butter on the surface of
the hot plate.
3. Close the lid of the Contact Grill.
The appliance is fully closed when the
locking clasp on handle audibly
snaps into position.
4. Insert the plug into a power socket to
switch the appliance on and set the temperature control knob at the desired
temperature. Now the Contact Grill starts
heating up.
The pilot light turns on.
5. After a few minutes the pilot light
switches off. Now the Contact Grill has
reached the set temperature and is ready
for operation.
Temperature settings
You can set the temperature control knob at
the following positions:
0 Switched off
I70° Defrost
II 130° Slow grilling
III 180° Medium grilling
M 260° Fast grilling
Hot plate positions
You can position the hot plates in different
ways depending on the preparation method.
Grill roasting / Plates in contact
This position is suitable for
simultaneous and fast roasting of
foodstuffs on both sides.
It is ideal for grilling meat that needs
to be seared fast at high temperature,
e.g. rump steak, filet cuts, chops,
sausages and vegetables.
1. Open the lid of the Contact Grill up to
the stopper without lifting it up.
2. Keep a cup under the ridge for
draining oil .
3. Place the food items to be grilled on
the bottom grilling hot plate .
4. Close the lid gently exerting slight pressure till the distance between both the
hot plates are adjusted automatically
depending on the thickness of the
food items.
Barbecue / Hot plate position 180° open
The specified temperatures are
reached when the grilling plates arein contact. In any other position there
will be a loss of heat and the desired
temperature may not be maintained.
The temperature setting depends on
the preparation method and the
nature of foodstuff.
The preparation time depends on the
nature and size of foodstuff.
6
This position is suitable for grilling
thick foodstuffs that need to be
roasted slowly and uniformly.
It is ideal for preparing vegetables
with high water content, as the water
can evaporate in the beginning at low
or medium temperatures.
You can also use this hot plate
position to prepare large quantities
of food items or to cook vegetables
along with meat.
1. Open the swivel support till the end.
2. Open the lid of the Contact Grill in vertical position, lift it up to the stopper and
open it further till it is in horizontal
position.
3. Keep two cups under the ridge for
draining oil on the hot plates.
4. Spread the grilling foodstuffs on both
the grill plates.
Oven function /Plate position parallel
distance approx. 7 cm
This position is suitable for preparing
delicate foodstuffs that need not
be pressed or turned over when
roasting.
It is ideal for grilling fish, baking small
pizza or pizza-baguette, or for
warming up bread rolls.
1. Open the lid part of the Contact Grill up
to the stopper without lifting it up.
2. Keep a cup under the ridge for
draining oil .
3. Place the foodstuff to be grilled on the
bottom hot plate .
4. Lift the lid till the stopper and turn it
forward till it rests in a parallel position
with the bottom hot plate.
After roasting
• Remove the grilled food items from the
hot plates using a wooden spatula or
any other suitable, non-metallic utensil.
• Set the temperature control knob to
"0" position.
Cleaning & Maintenance
• Before cleaning, unplug the
appliance and wait till it has
completely cooled down.
• Never attempt to clean the
appliance under running
water and never dip it in
water.
For normal cleaning, you can remove the
grilling hot plates from the appliance.
For this purpose, press the hot plate fixing
springs 6 slightly backwards to release
the hot plates.
Rinse the hot plates with hot water and a
neutral detergent. In order to protect the
non-stick coating, do not use any corrosive
detergents or pointed objects for cleaning.
In case the grill surface has become heavily
incrusted, keep a wet cleaning cloth on the
hard residual matter for a while to soak
the layer.
The hot plates should not be cleaned
in a dish washing machine.
To clean the external surface of the
appliance, use a wet cloth.
Before using the Contact Grill again, make
sure that all components are completely dry.
7
Storage
You can store away the Contact Grill in
horizontal or upright position. Your Contact
Grill has an integrated compartment for
storing the power cord at the bottom of the
housing. You can wind up the power cord in
it when the appliance is not in use. This way
you can prevent the power cord from getting entangled or soiled or from becoming a
likely cause of accidents.
Warranty & Customer Service
The warranty conditions and service
address can be found on the enclosed
warranty sheet.
Disposal
Dispose of the Contact Grill through a
certified disposal company or your
community disposal agency. Never
throw the Contact Grill into the normal
household waste.
Always obey the applicable regulations.
In case of doubt, contact your disposal
agency.
Declaration of conformity &
fabricant
Kompernass Handelsgesellschaft mbH,
Burgstrasse. 21, D-44867 Bochum,
Germany, hereby declares that this product
fully complies with all the applicable international safety standards, regulations and guidelines of the EU.
• EC low voltage regulations: 73/23/EWG
• EN 60335-1
• EN 60335-2-9
• Electromagnetic compatibility:
89/336 EWG
• EN 55014-1
• EN 55014-2
• EN 61000-3-2
• EN 61000-3-3
Appliance type / model: KH 1140
Bochum, 22.10.2003
H
Hans Kompernass, Managing Director
8
www.kompernass.com IDNr. KH1140-1103-V
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.