Kolpin 97947 User Manual

Rev.1

97947 – HID Lights

2010+ BRP Commander/Renegade

- You will be working with a few small parts. A clean workspace is very important for

properly functioning HID lights.

- Be very careful when working with HID light bulbs and ballast.

o NEVER TOUCH BULB! If bulb has been touched, clean with paper towel and

acetone to remove skin oil. Even if you can’t see it, your bulb will crack within a

few hours of use.

o NEVER TURN ON BALLAST WITHOUT BULB CONNECTED! If you do 23,000 volts

will be looking for somewhere to go. If it finds you, it makes 120ac house
voltage seem like a pinprick. Take our word for it; your arm will hurt all day.

- Remove all parts from the kit and read through the instructions. There are 3 main

components to the HID kit. The bulbs, the ballast and the wiring harness. It is a good
idea to mock everything up to check wire length and clearance issues.

- BRP's have 1 bulb for high and one bulb for low. Take a look and figure out which side

is low and high and what side to install the hid system.

- Remove the stock bulb and unplug the OEM wiring

- Remove plastic case from HID bulb being careful not to touch the bulb. Insert HID bulb

into the headlight reflector and turn approximately 1/3 of a turn until it locks.

- Mount ballast using self tapping screws or zip ties anywhere securely to the vehicle.

The ballast can get wet and don’t need direct airflow.

- Using the wiring pigtails find the stock wiring on each side and plug in the OEM plug

into wiring harness. Each side will need 1 bulb, ballast and adapter.

- Plug ballast plugs into ballast, taking care to plug in with correct polarity. They should

only go in correctly with a ramped clip retainer on one side, but they can be forced
incorrectly.

Kolpin Outdoors, Inc., 205 N. Depot Street, Fox Lake, WI Phone #: (877) 9KOLPIN or [phone] www.kolpin.com [e-mail]

Rev.1

- Plug the bulb into the male and female plugs on the ballast.

- Secure everything with zip ties and make sure one more time ballast are securely

mounted and no wires will get caught in the tires or suspension.

Enjoy your new lights!!

Kolpin Outdoors, Inc., 205 N. Depot Street, Fox Lake, WI Phone #: (877) 9KOLPIN or [phone] www.kolpin.com [e-mail]