Kolpin 97500 User Manual

Quad Carrier Mounting Instructions

WARNING!!

Failure to follow the instructions and warnings contained in this document and on the Quad

Carrier can result in severe injury or death.

Read and understand your ATV owner’s manual for risks associated with ATV use and

suitability of the Quad Carrier for use on you ATV.

ASSEMBLY:

1. Choose the best position for mounting the plates on your ATV rack.

2. Using the enclosed plastic cross braces, bolts, washers and nuts provided, position the

mounting plate in the desired location on your ATV. Put the bolts with washers
through the slot in the mounting plate and into the lock washers located in the cross
braces. Tighten securely. For best results, bracket should be mounted in three (3)
spots on your ATV rack.

3. Place the 30” Tube on the mounting plate using the 2 – 1.00” bolts and lock nuts.

CLAMP APPLICATION:

To use these clamps, place the clamp over the tubes and then unlock them into the release
position. Hand tighten the clamps and then fold them over into the locked position.

4. Place an arm on each end of the 30” pipe.

5. Use 1 clamp per arm to fasten the arms in the desired position.

6. Repeat these steps for the other half of the Kolpin Quad Carrier.

PARTS LIST

ITEM PART QUANTITY

1 Mounting Plates 2
2 30” Tube 2
3 Arm 4
4 Clamps 4
5 2 ½” Bolts 12
6 Lock Nuts 16
7 1” Bolt 4
8 Plastic Cross Braces 6
9 Washers 6

WARNING!!

NEVER TOW FROM QUAD CARRIER. Tow only from ATV tow hooks or hitch.
Towing by Quad Carrier may result in Vehicle Damage, Quad Carrier damage or
severe injury or death.

WATCH FOR CLEARANCE. Requires additional clearance especially through
narrow passages.

AVOID MOUNTING QUAD CARRIER NEAR MOVING PARTS. Interference
with moving parts may result in vehicle damage, Quad Carrier damage, or severe
injury or death.

NEVER

EXCEED LOAD CAPACITY. Quad Carrier is limited to hauling 50lbs of
material. Overloading Quad Carrier may result in vehicle damage, Quad Carrier
damage, or severe injury or death.