Kolpin 93202 User Manual

Hardware Pack Includes:
1 – RACK WELDMENT
4 – ¼” – 20 X 1” TRUSS HEAD BOLT
4 – ¼” – 20 WASHERS

INSTRUCTIONS –

1. USING A ¼” DRILL BIT, DRILL THE BOX FROM THE BOTTOM SIDE OF

THE LID. THERE ARE KISS OFFS MOLDED IN THE LID THAT WILL SHOW
YOU WERE YOU NEED TO DRILL. DUE TO THE TOLERANCE IN THE
PLASTIC AND THE WELDING PROCESS SOME HOLES MAY NEED TO BE
OVERSIZED TO ALLOW BETTER FITMENT OF THE RACK.

2. PLACE THE WASHER ONTO THE 1/4” X 1.00” TRUSS HEAD.

3. THREAD ALL 4 LOOSELY INTO THE “FEET” OF THE RACK. THIS WILL

ALLOW YOU TO MOVE AND ADJUST THE RACK TO FIT THE HOLE
PATTERNS AS NEEDED. ONCE ALL 4 ARE STARTED, YOU MAY
TIGHTEN THE RACK SECURELY.

4. CLEAR OR BLACK SILICONE CAN BE ADDED TO THE CONNECTION

BETWEEN THE FEET AND THE TOP OF THE LID TO HELP SEAL OUT
WATER.

5. BE SURE TO CHECK THE HARDWARE PERIODICALLY TO ENSURE

PROPER TENSION.

Rev. 1

93202 – ACCESSORY RACK

(FOR 93201 AND 93450 BOXES)

93202 RACK SHOWN ON 93201 BOX

Kolpin Outdoors, Inc. 205 N. Depot Street, Fox Lake, WI 53933 Phone #: (877) 9KOLPIN or [phone]

www.kolpinpowersports.com [e-mail]