Kole Audio electronic KLE-10 User Manual

Kole Audio KLE Woofers

Congratulations on your purchase of one of the finest woofers available for your vehicle today.

Adding affordable bass to your system was never easier with Kole Audio’s KLE Series woofers. Kole
Audio’s engineers used the combination of a Polypolne cone and a rubber progressively slanted surround to
give you dependable affordability in a woofer that can be used in a sealed or ported enclosure.

Please take a few moments to fill out the warranty card and review this manual before installing this woofer
for proper connections and box sizes.

Heavy-Gauge, Specially Designed Steel Baskets
Blue Polypolne Cones w/Raised Conical Dust Caps
Progressively Slanted Butyl Rubber Surround
Single 4-ohm, 4-Layer Kapton Voice Coils
Black Spider
Chrome Front & Back Plates
Rubber Magnet Cover
Chrome Push Terminals
SPL: 10” – 91 dB 12” – 92 dB
Magnet size: 10”- 55oz. 12” – 60oz.
Voice Coil sizel: 10” – 2.0” 12” – 2.0”
RMS Power (watts): 10” –250 12” – 300
MAX Power (watts): 10” – 500 12”- 600

Thiele / Small Parameters

KLE-10
Fs 31.3 Hz 31.9 Hz

Vas 1.05 Cu. Ft. 1.86 Cu. Ft.
Qms 5.235 2.97
Qes 0.472 0.638
Qts 0.4325 0.525

Xmax 0.315” 0.315”

Design Features

KLE-12

Model Sealed Box Size Ported Box Size Tune Freq. # of Ports Port (dia x length)

KLE-10 .5 cubic feet 1.6 cubic feet 35 Hz 1 3" x 8.25"
KLE-12 1.0 cubic feet 3.0 cubic feet 38 Hz 1 3" x 3"

• Determine the dimensions of your enclosure.

• Be certain the box dimensions that you have designed will fit in the location you

have chosen in your vehicle. Sometimes making a cardboard box with the same
outside dimensions is helpful.

• It is recommended to use ¾ inch thick MDF (medium density fiberboard) for your

box.

• Use a “T” square to verify precise right angle cuts before you assemble the box.

• Use high quality wood glue and screws to assemble the box to guarantee an

airtight box that will not come apart due to excess vibration and pressure.

• It is recommended for sealed enclosures to stuff the interior of the box about 50 –

75% fiberglass insulation or Dacron fiberfill for increased sound damping and
woofer performance.

• For ported enclosures, it is recommended to staple 1” thick fiberglass insulation to

the interior walls of your box.

• Use slide on connectors for spade style connectors or bare wire for push and

screw terminals. Do not solder the wires to the factory connectors as this may
cause damage to the voice coil or tinsel lead and may void your warranty.

The following page will give you a few different options to match the impedance of the
woofers to the impedance capability of the amplifier. Please look and follow the diagrams
closely to insure maximum woofer performance.

Recomme nded box sizes

Building the Enclosure

Recommended wiring