Kohler Renew 98351T Installation Instructions Manual

INSTALLATION INSTRUCTIONS

RENEW

98351T Wall Mount Connection

BEFORE YOU BEGIN

All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.

Please leave these instructions for the consumer. They contain important information.

ROUGH-IN DIMENSIONS

58

INSTALLATION

51

58

1

2

G1/2˝

15~23

Before installation, installer must provide G1/2″ female supply
fitting(1).

Apply tape or thread sealant to G1/2″ threads of the outlet
bush(2). Install the outlet bush onto the supply fitting. Secure
it with a wrench and make it extend 32~39mm beyond the
finished wall. NOTE: Don’t drop the o-rings(3).

59

38

44

G1/2˝

4

Loosen the screw(5) in the bottom of the connectoin kit(4)

5

3

1240380-2A-D 1

with the hex wrench(3), make the outlet bush can be installed.

NOTE: Do not fall the parts in the kit off.

2

Put the connection kit(4) into the escutcheon(6), confirm the
drain notch of the escutcheion is pointed down.

6

4

Apply a ring of plumber putty or other sealants around the
underside of the escutcheon. Install the connection kit(4) and
escutcheon onto the outlet bush(2) until against the finished
wall. Adjust the connection kit and make sure the outlet(7)
downwards.

Drain notch

7

Tighten the screw(5) in the bottom of the kit by the hex
wrench(3). Remove any excess putty.

5

3

CLEANING INSTRUCTIONS

All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Kohler faucets and fittings.

SERVICE PARTS

1240785

1194751**

1081607

1208172

**Color code must be specified when ordering

1240380-2A-D 2