Kohler PATIO URINAL Installation Instructions Manual

PATIO

INSTALLATION INSTRUCTIONS

VITREOUS CHINA URINAL

-1-

1063245-T01-B

K18645A

A. How to use these instructions

• Please read these instructions carefully to familiarize yourself with the required tools, materials, and installation sequences. Follow the
sections that pertain to your particular installation. This will help you avoid costly mistakes. In addition to proper installation, read all
operating and safety instructions.

• All information in these instructions is based upon the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.

• These instructions contain important care, cleaning, and warranty information - Please leave instructions for the consumer.

B. Notes

• Observe all local plumbing and building codes.

• Shut off the water supply.

• Carefully inspect the new fixture for any sign of damage.

• Be very careful while hand ling vitreous china products.

C. Required tools and materials

• Drill

• Open end/adjustable wrenches

• Measure tape

• Thread sealant tape

• Basin Wrench

• Screwdriver

• Sealant

• Touchless Urinal Sensor or other assy. for flow controlling (Recommended Kohler Touch-less urinal Sensor K-8787T-C02/K-8791T-C02).

• Recommend the no less than 9mm stainless steel twist pipe as inlet.

A. Install Urinal Sensor

Recommended Urinal Sensor Kohler Urinal Sensor 8787T-C02/8791T-C02

B. Install Outlet Connection

• Ascertain the position for outlet connection according to rough-in.

• Apply sealant on outlet pipe. and connect the outlet connection with outlet pipe. Insert gasket as shown in Fig.2.

• Fix outlet connection on the installing wall.
Note: Fig.2 may be different for different outlet connection.

Unit: mm

ROUGHING-IN

335

180

35

265 5

140

80

600

50 ext

145

70

642

300

95

370

G1/2

INSTALLATION

Fig.1

-2-

1063245-T01-B

2~10mm

100

30

Fig.2

Fig.3

Fig.4

C. Install hook

D. Install inlet pipe

Insert gasket and nut into the uriral as shown. Connect the inlet connection with inlet pipe.

(See Fig.3)
Drill 2 mounting holes on the wall and install hook. Fix hook on the wall by tightening screws.

265

08

210

600

081

310

X
+

35

001