Kohler M MODULAR Installation Instructions Manual

BEFORE YOU BEGINBEFORE YOU BEGIN
M
M MODULAR
INSTALLATION INSTRUCTIONS
()
MIRRORED CABINET W/DEFOGGER
K-15512T
·
Please read these instructions carefully to familiarize yourself with the required tools, materials, and installation sequences. Follow the sections that pertain to your particular installation . This will help you avoid costly mistakes. In addition to proper installation, read all operating and safety instructions.
·
All information in these instructions is based upon the latest product information available at the time of publication. Kohler China. reserves the right to make changes in product characteristics, packaging, or availability at any time without notice.
·
These instructions contain important care, cleaning, and warranty information-
please leave instructions for the
consumer.
·
Before installation carefully inspect the new fixture for any signs of damage.
WARNING: Risk of injury or product damage.
Tempered glass cannot be cut.
WARNING:
Don't use acidic or alkalic cleaners or alcohol to clean the wooden surface. Use a dampened cloth to clean.
PARTS
Parts supplied with your cabinet. (For cabinet body and door replacement, call customer service with model number.) Be sure to check the cardboard supports in the carton, glass parts are packed in them.
·
·
·
·
-
ACCESSORIES LISTACCESSORIES LIST
Glass Shelves
X3
Snap-in Pins
X12
Screws ST4.2 12
X8
Wall Anchors
X5
ST4.2 12
Top Clips
X2
Connector Block
X2
Caps of Screw
X10
Hinge Clips
X2
Screws ST3.5 35
ST3.5 35
X5
Glass
X1
13-1 528437
Hole Plugs
X40
2 Level Box
X1
Mounting Bar
X1
Tissue Box
X1
1179057-T01-A
-1-
, 2011
ROUGHING-IN
UNIT : mm
PRE-DRILLED HOLEPRE-DRILLED HOLE
Pre-Drilled Hole for Side Kits
Pre-Drilled Hole for Cabinet-to-Cabinet
735
99 116
762
489
Pre-Drilled Hole for Recessed Cabinet
1179057-T01-A
-2-
406
682
INSTALLATION
NOTE
The cabinet has two ways of installation:
Recessing mounting.
·
Surface mounting.
·
Refer to the following instruction for mirror installation.
RECESSING THE MIRRORED CABINET INTO THE WALL
The Vertical installation changes the width of the roughout. Please refer to the picture below.
472mm for Width
472mm
·
·
745mm high
745mm
Screws ST3.5 35
ST3.5 35
Fig. 1 1
On installations of larger cabinet in combinations of 3 or more, the center door, when open, may cause the cabinet to bow from the wall. If this happens, drill a hole at the location shown in Figure J and install a ST3.5X35 SCREW.
3
ST3.5X35
3/4"
(19.1mm)
3/4"
(19.1mm)
Figure J
1179057-T01-A
Drill a hole through
Top of middle cabinet 3/4" (19.1 mm) from back
19.1mm
STEP
1
-3-
Loading...
+ 5 hidden pages