Features
•
Project Pack: Supplied 12 per case
•
Includes valve body, rough-in guide and test cap
•
1/2" PEX Expansion (F1960 style) inlets
•
1/2" Universal NPT & direct sweat outlets
•
Requires valve cartridge and trim to complete installation (sold
separately).
Material
•
Forged De-zincification Resistant Brass body provides long
term reliability and resistance to aggressive water conditions
Installation
•
Designed for use in standard, back to back and thin wall
installations
•
Valve body features integral mounting locations and symmetrical
valve inlets to simplify installation
•
Rough-in guide designed for both standard and thin wall
installations
•
Installed valve rough-in can be flushed and pressure tested to
150psi max (air or water) without cartridge, using K-10351 Test
Cap (supplied)
Rite-Temp
Valve Body Rough-In
K-P8300-UX
Codes/Standards
ASME A112.18.1/CSA B125.1
KOHLER® Faucet Lifetime Limited
Warranty
See website for detailed warranty information.
®
Required Products/Accessories
K-8305/K-P8305 Series Rite-Temp® Cartridges
or
K-8305/K-P8305 Series Rite-Temp® Cartridges
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
1-31-2019 18:48 - US/CA
Inlet Port
Rite-Temp
®
Valve Body Rough-In
K-P8300-UX
Technical Information
All product dimensions are nominal.
Machined-brassValve body:
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
1-31-2019 18:48 - US/CA
Notes
Install this product according to the installation
guide.
Avoid cross-flow conditions. Do not install shut-off
device on either valve outlet.
Cap the shower outlet if deck-mount spout,
diverter, or handshower is connected to the spout
outlet.
Install straight pipe or tube drop of 7" (178 mm)
to 18" (457 mm) with single elbow between the
valve and wall-mount spout.
For finished walls greater than 3/4" (19 mm) and
less than 1-1/2" (38 mm), install support(s) 2" (51
mm) from the stud face.
For finished walls greater than 1-1/2" (38 mm),
install support(s) 3" (76 mm) from the face of the
finished wall.
Loading...