Roughing-In
K-1139-H, K-1139-LH, K-1139-RH
PROFLEX
®
6036
WHIRLPOOL BATH WITH HEATER
Product Information
Applicable products:
Whirlpool bath with heater - drop-in (shown) K-1139-H
Whirlpool bath with heater - left drain hole,
tile flange
Whirlpool bath with heater - right drain hole,
tile flange
Fixture*:
Bathing well:
Basin area, bottom 46″ (1168 mm) x 15″ (381 mm)
Basin area, top 55″ (1397 mm) x 25″ (635 mm)
Weight 60 lbs (27.2 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 57 gal (215.8 L)
* Approximate measurements for comparison only.
Drop-in cutout 58-1/2″ (1486 mm) x 34-1/2″ (876 mm)
Pump: V Hz A
1-speed 120 60 7.5
K-1139-LH
K-1139-RH
Heater: kW V Hz A
1.5 120 60 12.5
Required Electrical Service
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Locate the outlets behind the whirlpool and within 24″
(610 mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
37 lbs/square foot (183 kg/square meter) loading.
The apron must be installed before the finished floor and wall
materials are installed.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
18"
(457 mm)
1"
(25 mm)
2-1/2"
(64 mm)
3"
(76 mm)
8" (203 mm)
60" (1524 mm)
2-7/8"
(73 mm)
3/8" (10 mm)
Lumbar
Angle 29˚
18-1/8"
(460 mm)
No change in measurements if connected
with drain illustrated. (K-11677)
1-1/4"
(32 mm)
Pump/Control Access
(If Apron Is Not Used)
20" (508 mm) W x
15" (381 mm) H
Tile Flange
Detail
36" (914 mm)
1-1/2"
(38 mm)
16-5/8"
(422 mm)
Drop-in Rim
1-1/2" Bath Drain
Detail
PROFLEX®6036 WHIRLPOOL BATH WITH HEATER
1013750-1-
E
Loading...