Page 1
TEA-FOR-TWO
®
Features
Cast iron with Safeguard
•
Blower motor with 300 W heater and electronic
•
back-lit user control
44 BubbleMassage
•
18 levels of airflow adjustability
•
With Zones of Control
•
features
60″ (1524 mm) x 32″ (813 mm) x 18-1/4″ (464 mm)
•
TM airjets
finish
®
TM, surge, and automatic purge
Codes/Standards Applicable
Specified model meets or exceeds the following:
ADA
•
ICC/ANSI A117.1
•
ASME A112.19.1/CSA B45.2
•
ASME A112.19.7
•
CSA C22.2 No 218.2
•
UL 1795
•
5’ (1.5 m) BUBBLEMASSAGETM BATH
K-852-G
Colors/Finishes
0: White
•
CP: Polished Chrome
•
NA: None applicable
•
Other: Refer to Price Book for additional colors/finishes
•
Specified Model
Model Description Airjet Trim Color Colors/Finishes
K-852-G 5’ (1.5 m) BubbleMassage bath ❑ CP ❑ Other_____ ❑ 0 ❑ Other_____
Required Accessories
K-7169-AF Pop-up bath drain ❑ CP ❑ Other_____
Optional Accessories
K-586 Undermount installation kit (template and installation guide) ❑ NA
K-1491 Removable pillow ❑ 0 ❑ Other_____
K-1601 Removable footstop ❑ 0 ❑ Other_____
K-1172 Adjustable feet ❑ NA
K-1705 Remote control ❑ NA
K-9498 3″ (76 mm) keypad trim ❑ CP ❑ Other_____
Product Specification
The BubbleMassage bath shall be made of cast iron with Safeguard finish. Bath shall be 60″ (1524 mm) in length, 32″ (813 mm)
in width, and 18-1/4″ (464 mm) in height. Bath shall have 44 BubbleMassage airjets. Bath shall have a blower motor with 300
W heater and electronic back-lit user control. Bath shall have 18 levels of airflow adjustability. Bath shall be with Zones of
TM, surge, and automatic purge features. Bath shall be Kohler Model K-852-G____-____.
Control
Page 1 of 2
1146819-4-
USA/Canada: 1-800-4KOHLER
B
(1-800-456-4537)
www.kohler.com
Page 2
TEA-FOR-TWO
Technical Information
®
Required Electrical Service
Fixture*:
Bathing well:
Basin area,
bottom
Basin area, top 52-3/4″ (134 mm) x 24″ (610 mm)
Weight 290 lbs (131.5 kg)
To overflow:
Water depth 13-5/8″ (346 mm)
Capacity 60 gal (227.1 L)
* Approximate measurements for comparison only.
Drop-in cut-out 58-1/2″ (1486 mm) x 30-1/2″ (775 mm)
Cut-out for
undermount
Blower
motor:
Heater V Hz A
300 W 220-240 50/60 3
1-5/8"
(41 mm)
40-1/2″ (1029 mm) x 20″ (508 mm)
K-586
60" (1524 mm)
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor/control 220-240 V, 15 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
NOTICE: If the blower motor and check valve are
relocated, two access panels are required. Locate one
access panel at the blower motor/control location and the
other at the control box. Locate the blower motor and check
valve together.
Will comply with ADA when installed per Section 607
Bathtubs of the Act.
Floor support under bath must provide for a minimum of 60
lbs/square foot (290 kg/square meter) loading.
Splitting the deck/surround is recommended if installing into a
deck.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
2-1/2"
(64 mm)
16"
(406 mm)
2-1/2"
(64 mm)
2-7/8"
(73 mm)
14" (356 mm)
3" (76 mm)
1/4" (6 mm)
NOTE: Blower protrusion beyond the rim.
Product Diagram
No change in measurements if connected with
drain illustrated. (K-7169-AF)
Blower Motor/Control Access
34" (864 mm) W x
15" (381 mm) H
3/4"
(19 mm)
32" (813 mm)
18-1/4"
(464 mm)
1-1/2" OD
TEA-FOR-TWO®5’ (1.5 m) BUBBLEMASSAGETM BATH
Page2of2
1146819-4-
B
Loading...