Page 1
Roughing-In
K-1139, K-1139-L, K-1139-R
PROFLEX
®
6036
WHIRLPOOL BATH
Product Information
Applicable products:
Whirlpool bath – drop-in (shown) K-1139
Whirlpool bath – tile flange, left drain K-1139-L
Whirlpool bath – tile flange, right drain K-1139-R
Fixture*:
Bathing well:
Basin area, bottom 46″ (1168 mm) x 15″ (381 mm)
Basin area, top 55″ (1397 mm) x 25″ (635 mm)
Weight 55 lbs (25 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 57 gal (216 L)
* Approximate measurements for comparison only.
Drop-in cutout 58-1/2″ (1486 mm) x 34-1/2″ (876 mm)
Pump: V Hz A
1-speed 120 60 7.5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Locate the outlet behind the whirlpool and within 24″
(610 mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
37 lbs/square foot (181 kg/square meter) loading.
The apron must be installed before the finished floor and wall
materials are installed.
This fixture conforms to CSA B45.5/IAPMO Z124. All
dimensions are nominal.
18"
(457 mm)
1"
(25 mm)
2-1/2"
(64 mm)
3"
(76 mm)
8" (203 mm)
60" (1524 mm)
2-7/8"
(73 mm)
3/8" (1 mm)
No change in measurements if connected with drain
illustrated. (K-11677)
Lumbar
Angle 29˚
18-1/8"
(460 mm)
Pump/Control Access
(If Apron is Not Used)
20" (508 mm) W x 15" (381 mm) H
36" (914 mm)
16-5/8"
(422 mm)
1-1/2" Bath Drain
1-1/4"
(32 mm)
Tile Flange
Detail
1-1/2"
(38 mm)
Drop-in Rim
Detail
PROFLEX®6036 WHIRLPOOL BATH
1013749-1-
E
Loading...