Kohler K-6352, K-6353 User Manual

Installation Guide

Single-Control Kitchen Sink Faucets

K-6352 K-6353

M product numbers are for Mexico (i.e. K-12345M)
Los números de productos seguidos de
M corresponden a México (Ej.
K-12345M)
Français, page“ Français-1”
Español, página“ Español-1”

1025494-2-B

Tools and Materials

Assorted
Screwdrivers

Adjustable
Wrench

Plumbers
Putty

Pipe
Wrench

Strap
Wrench

5/64" Hex
Wrench

Thread
Sealant

Tube Cutter

Socket Wrench with
7/16" Deep Socket

Pliers

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don’t
hesitate to contact us. Our phone numbers and web site are listed on
the back cover. Thanks again for choosing Kohler Company.

Before You Begin

Observe all local plumbing codes and building codes.
Shut off the water supplies.
Carefully inspect waste and supply tubing for any sign of

damage and replace if necessary.
For new installations, assemble the faucet and drain to the sink

before installing it.
Before installation, unpack the new faucet and inspect it for

damage. Return the faucet to the carton until you are ready to
install it.

Do not remove the faucet ground joints, as they contain
important back-siphonage protection.

Do not attach a dishwasher to the faucet spray outlet.
Kohler Co. reserves the right to make revisions in the design of

faucets without notice, as specified in the Price Book.

1025494-2-B 2 Kohler Co.

Faucet Body

Hose

Escutcheon

Rubber
Washer

Spacer

O-Ring

1. Install the Mounting Stud

Disconnect the hose from the hose connector.
Screw the mounting stud into the threaded hole at the bottom of

the faucet body. The mounting stud should extend slightly
beyond the threaded hole in the body.

1. Install the Escutcheon (Optional)

NOTE: For installation on marble, do not use plumbers putty. Use
the self-adhesive gaskets provided. Remove the paper backing and
apply the gaskets (adhesive side down) over the outside holes.

For 1-hole Installations:

The escutcheon, spacer, and O-ring are not required. .Slide the
rubber washer over the faucet tubing and hose.

Insert the faucet tubing and hose into the hole.

For 3–hole Installations:

Apply a ring of plumbers putty to the underside of the
escutcheon according to the putty manufacturer’s instructions.

Insert the O-ring into the groove in the spacer.
Slide the rubber washer, escutcheon, and spacer (O-ring side

down) over the faucet tubing and hose.
Insert the faucet tubing and hose into the center hole, carefully

aligning the escutcheon.
Press down on the escutcheon and remove any excess putty.

Kohler Co. 3 1025494-2-B