DEVONSHIRE
®
Features
Acrylic
•
Blower motor is supplied with a grounding-type
•
plug-in cord
Integral apron with removable access panel
•
Integral tile flange
•
Left or right drain
•
120 BubbleMassage
•
Molded lumbar supports and armrests
•
Blower motor with 300 W heater and electronic user
•
control
60″ (152.4 cm) x 32″ (81.3 cm) x 20″ (50.8 cm)
•
TM airjets
Codes/Standards Applicable
Specified model meets or exceeds the following:
ANSI Z124.1.2
•
IAPMO IGC 171
•
UL 1795
•
ASTM E162
•
ASTM E662
•
Specified Model
5’ BUBBLEMASSAGETM BATH
K-1357-GLA
ALSO K-1357-GRA
Colors/Finishes
0: White
•
Other: Refer to Price Book for additional colors/finishes
•
Accessories
CP: Polished Chrome
•
PB: Vibrant®Polished Brass
•
NA: None applicable
•
Other: Refer to Price Book for additional colors/finishes
•
Model Description Colors/Finishes
K-1357-GLA 5’ Bubblemassage bath – left drain ❑ 0 ❑ Other_____
K-1357-GRA 5’ Bubblemassage bath – right drain ❑ 0 ❑ Other_____
Recommended Accessories
K-1446 Remote blower installation kit NA
K-7161-AF Adjustable pop-up drain ❑ CP ❑ PB ❑ Other_____
Product Specification
The acrylic Bubblemassage bath shall be 60″ (152.4 cm) in length, 32″ (81.3 cm) in width, and 20″ (50.8 cm) in height. Product
shall have an integral apron with removable access panel and integral tile flange. Product shall feature molded lumbar supports
and armrests. Product shall be available with left or right drain. Product shall feature a blower motor with 300 W heater, and an
electronic user control. Blower motor shall be supplied with a grounding-type plug-in cord. Product shall have 120
Bubblemassage airjets. Bubblemassage bath shall be Kohler Model K-1357-____-____.
Page 1 of 2
1040137-4-
C
USA/Canada: 1-800-4KOHLER
(1-800-456-4537)
www.kohler.com
DEVONSHIRE
®
Technical Information
Required Electrical Service
Fixture*:
Bathing well:
Basin area, bottom 42″ (106.7 cm) x 20″ (50.8 cm)
Basin area, top 51″ (129.5 cm) x 24″ (61 cm)
Weight 98 lbs (44.5 kg)
To overflow:
Water depth 14-1/2″ (36.8 cm)
Capacity 60 gal (227.1 L)
* Approximate measurements for comparison only.
Blower motor: Heater V Hz A
300 W 120 60 5
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor 120 V, 15 A, 60 Hz
Blower motor is supplied with a 24″ (61 cm)
grounding-type plug-in cord.
Installation Notes
NOTICE: If the blower motor and check valve are
relocated, the following two procedures are required: 1.
Provide two access panels. Locate one access panel at the
blower motor/control location and the other access panel at
the control box. 2. Relocate the blower motor and the check
valve together. Do not relocate one without the other.
Install this product according to the installation guide.
Floor support under the bath must provide for a minimum of
47 lbs/square foot (229 kg/square meter) loading.
No change in measurements with drain
shown. (K-7161-AF or K-7161M-AF)
16"
(40.6 cm)
2-1/4"
(5.7 cm)
3"
(7.6 cm)
1-1/2" OD
9" (22.9 cm)
60" (152.4 cm)
2-1/2"
1" (2.5 cm)
(6.4 cm)
21-1/4"
(54 cm)
Product Diagram
1-1/4"
(3.2 cm)
1/2"
(1.3 cm) R.
Integral Flange Detail
32" (81.3 cm)
20"
(50.8 cm)
DEVONSHIRE®5’ BUBBLEMASSAGETM BATH
Page2of2
1040137-4-
C