Kohler K1162H47 Specifications

Roughing-In

K-1162-H

SUNWARD

BATH WHIRLPOOL WITH HEATER

®

Product Information

Applicable product:
Bath whirlpool with heater K-1162-H

Fixture*:
Bathing well:
Basin area,

bottom
Basin area, top 53-1/2″ (135.9 cm) x 32-1/8″ (81.6 cm)
Weight 110 lbs (50 kg)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 57 gal (215.9 L)
* Approximate measurements for comparison only.

Included components:
Cut-out template 1042556-7

Pump: V Hz A
1-speed 120 60 7.5
Heater: kW V Hz A

43″ (109.2 cm) x 21-9/16″ (54.8 cm)

1.5 120 60 12.5

Minimum access panel pump/control:
20″ (50.8 cm) W x 15″ (38.1 cm) H required

Required Electrical Service

Two dedicated circuits are required, each protected with
a Class A Ground-Fault Circuit-Interrupter (GFCI):

Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Locate the outlets behind the whirlpool and within 24”

(61 cm) of the pump and heater.

Installation Notes

Install this product according to the installation guide.

Floor support under whirlpool must provide for a minimum of
35 lbs/square foot (170 kg/square meter) loading.

The suction line extends 4-5/8″ (11.7 cm) beyond the edge of
the rim. The pump base extends 1/8″ (3.3 mm) beyond the
edge of the rim. Modify the framing as needed.

Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.

21"
(53.3 cm)

3-1/8"
(7.9 cm)

3-1/2"
(8.9 cm)

10-13/16" (27.5 cm)

60" (152.4 cm)

2-7/8" (7.3 cm)

3" (7.6 cm)

4-5/8" (11.7 cm)

3/8" (1 cm)

No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)

Pump/Control
Access

21"
(53.3 cm)

19-1/2"
(49.5 cm)

Recommended faucet area

1-1/2"
(3.8 cm)

Drop-In Rim Detail

42" (106.7 cm)

1-1/2" OD

SUNWARD®BATH WHIRLPOOL WITH HEATER
1041934-1-

E