Kohler K1154FH96 Maintance Manual

Acrylic Baths & Whirlpools

For best results, keep the following in mind when caring for your KOHLER®
product:

 Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
 Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and dry any overspray

that lands on nearby surfaces.

 Do not allow cleaner to soak.
 Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean

surfaces.

 For warranty information call 1-800-4KOHLER (1-800-456-4537).

* Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the
water, using exact measurements of ingredients, changes in cleaning formulas and the condition of the product being
cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas.

_____________________________________________________________________________________________

 Wipe out bath/whirlpool after each use with soft cloth or squeegee.

 Do not use abrasive cleaners.

 Avoid using aerosol products on the bath surface.

Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the

For rust removal:

water, using exact measurements of ingredients, changes in cleaning formulas and the condition of the product being
cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas
mentioned.

Care Tip

To restore dull or scratched units: Apply white automotive polishing compound with a clean cloth. Rub scratches and
dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax.

Do not wax areas where you walk or stand. Damaged surfaces can be repaired. Check the Yellow Pages under
"Fiberglass-Repair."

Products to Consider

Mr. Clean Disinfecting Bath Cleaner with Febreze Freshness

Tilex Bathroom Cleaner