Kohler 10089W-CP, 10091W-CP, 10098W-CP User Manual

1

1081774-W2-A

IMPORTANT

INSTALLER: THIS MANUAL IS THE PROPERTY OF THE

CUSTOMER AND MUST BE RETAINED WITH THE PRODUCT

FOR MAINTENANCE AND OPERATIONAL PURPOSES.

Installation and User Guide

Oblo Deck and Wall Mounted Bath/Shower

Mixers and Wall Mounted Thermostatic

Shower

MODEL NUMBERS

Important! Please quote the above model number(s) when ordering spares

10089W-CP, 10091W-CP, 10098W-CP

2

1081774-W2-A

CONTENTS

Specication ............................................................................................2

Pressures ............................................................................................. 2

Temperatures .......................................................................................2

Installation ...............................................................................................3

Before you Begin ..................................................................................3

Install the Wall Mounted Mixer ............................................................. 3

Install the Deck Mounted Mixer ............................................................4

Connect the Shower Fittings ................................................................ 5

Finish the Installation ............................................................................5

Operation ..............................................................................................5

User Maintenance .................................................................................... 6

Cleaning ............................................................................................... 6

Spare Parts ..............................................................................................6

Dimensions ..............................................................................................7

Customer Care ......................................................................................... 8

SPECIFICATION

Pressures

The minimum recommended operating pressure is 0.5 bar.

For optimum performance, a minimum operating pressure of 1.0 bar is
recommended.

Temperatures

Minimum hot water supply temperature: 50°C

Maximum hot water supply temperature:70°C

Recommended hot water supply temperature: 60°C

Temperature adjustment range (approximate): 20°C - 50°C

Safety button set at: 38°C

Maximum hot water temperature from mixer: 50°C

3

1081774-W2-A

Install the Wall Mounted Mixer

1. Install the bath and drain (refer to the manufacturer’s instructions).

Note! When wall mounting the mixer it should be noted that the product is supported
by the pipework only.

2. Make sure that the connectors are level and set at the correct distance apart.

Note! Make sure that the connectors extend 40 - 45 mm from the nished wall.

3. Screw on the concealing plates hand tight.

4. Position the washer on each of the nuts.

5. Align the mixer and connectors and tighten the nuts using the special tool
supplied.

Note! Make sure that you do not damage the chrome plated surfaces when

you tighten the nuts.

INSTALLATION

Before you Begin

1. Make sure that the tap is installed by a competent installer.

2. Turn off the water supply.

3. The plumbing installation must comply with Building Regulations or any

particular regulations and practices, specied by the local water company or

water undertakers.

150 mm

Spirit Level

40-45 mm

1

2

3

4

1081774-W2-A

Install the Deck Mounted Mixer

1. Install the two column connectors to the mixer.

2. Install the grub screw and tighten with a hexagonal wrench.

3. Place the concealing plate over the threaded section of the column
connectors.

4. Apply a ring of sealant in accordance with the manufacturer’s instructions
underneath the concealing plates.

5. Fit the mixer through the top of the bath.

6. Install the washers and the locknuts. Use a tap spanner to tighten the nut.

7. Remove any excess sealant.

1

2

Concealing Plate

Locknut

Washer

Apply Sealant

5

1081774-W2-A

Connect the Shower Fittings

1. Install the shower ttings (refer to the manufacturer’s instructions).

2. Connect the shower ttings to the mixer.

Finish the Installation

1. Make sure that the mixer knobs are in the off position.

2. Turn on the hot and cold water supplies and check for leaks from both the mixer
and the drain.

3. Use the special key (provided) to unscrew and remove the aerator.

4. Turn on the hot and cold knobs and allow the water to run for approximatley
one minute to remove any debris.

5. Turn the hot and cold knobs to the off position and re-install the aerator using
the special key.

Operation

Set the temperature by slowly turning the temperature selector (right handle).

For safety reasons there is a stop that limits the tempeature to 38°C. To get a higher
temperature, push the button and contiue turning the temperature selector

Tool

Aerator

Shower

6

1081774-W2-A

Cleaning

Many household cleaners contain abrasive and chemical substances, and should

not be used for cleaning plated or plastic ttings.

These nishes should be cleaned with a mild washing up detergent or soap solution,

and then wiped dry using a soft cloth.

USER MAINTENANCE

E8A525-CP
Temperature Handle

R29701241
Spline Adapter

R8A532NF
Aerator

R8A526NF
Fixed Stop

E8A534CP
Concealing Plates

R29927969
Outlet

SPARE PARTS

R8A527NF
Nut

R8A528NF
Thermostatic
Cartridge
Assembly

E8A531-CP
Divertor

R8A530NF
Ceramic Valve

R29701241
Spline
Adapter

E8A529-CP
Flow Handle

R8A026NF
Checkvalve
and Filter

E8A510-CP
Concealing
Plate

R8A009NF
Mounting Kit

E8A533-CP
Deck Mount

7

1081774-W2-A

DIMENSIONS

All dimensions in mm

20max

150±15

G1/2

190

G1/2

Ø

58

85 min

92 max

57°

G1/2

57

°

105

208

180

65

G1/2

20max

150±15

G1/2

Ø

58

90 max

G1/2

83 max

10089W

10098W

10091W

8

1081774-W2-A

© Kohler Mira Limited, April 2007

CUSTOMER CARE

Guarantee of Quality

Kohler UK guarantee products against any defect of materials or workmanship for the following periods

To register and fully benefit from this guarantee you must
return the enclosed product registration card indicating
the Kohler items you have purchased.
Within the guarantee period we will undertake to resolve
any material defects, by providing replacement parts,
modules or complete product, as we deem appropriate.
To be free of charge, work must only be undertaken by
Kohler UK approved personnel.
To ensure that any problems can be promptly resolved
you must contact Kohler UK directly.
Proof of purchase must be provided with any claims.

This guarantee covers products in domestic use, installed
and maintained in accordance with the instructions. It
covers the purchaser only and is not transferable.

Commercial / Business Use

Any Kohler Bathroom product used within a commercial /
business premise is guaranteed for 1 Year against any
defect of materials or workmanship.

Not Covered by this Guarantee

Damage or defects arising from incorrect installation,
improper use or lack of maintenance.
Installed product damaged in transit Consequential loss,
damage or product removal and installation costs.
General wear and tear.

This guarantee is in addition to your statutory and other
legal rights.

Ceramic Ware and Cast Products

Shower Valves, Taps, Cistern

Fittings, Toilet Seats and Bath

Panels

Bathroom Furniture and

Accessories

Whirlpool / Spa Baths

Stainless Steel Products and, Acrylic Baths

To Contact Us

Kitchen and Bathroom Taps and Accessories

Tel: [phone]
Fax: [phone]
Email: [e-mail]
Website: www.kohleruk.com

Showers and Fittings

Tel: [phone]
Fax: [phone]
Email: [e-mail]
Website: www.kohleruk.com

All other Kohler Products

Tel: [phone]
Fax: [phone]
Email: [e-mail]
Website: www.kohleruk.com

Our confidence in the quality and reliability of our superior products enables us to offer a

comprehensive guarantee for all products.