Kogan ZA Smart TV Series Quick Start Manual

ZA Smart TV Series

QUICK START GUIDE

GETTING STARTED

Unpacking your Television

Ensure the following accessories are included in the box with your TV.

• Remote control and batteries
(2 x AAA)

• Quick Start Guide

• Link to Full User Manual

• TV Stand and 5 x Screws

Assembling your Stand

For large TVs, we recommend having a second person assist you in safely
removing the TV from the box.

Ensure you have the following tools and cables available to get up and
running as fast as possible.

~ Philips-head Screwdriver
~ Coaxial (RF) Cable

Attaching the Stand

With help from another person, remove the TV from the box and lay it face
down on large flat surface. Attach the stand using the screws provided with
a Philips-head screwdriver.

Positioning your TV

• Position your TV in it's final resting
place.

• Remove all protective sleeves and
plastic stickers from the TV.

• Ensure there is approximately
10cm of space around the TV for
ventilation.

Powering On

Plug in the power cord
and switch on the power.
Check the hard power
switch and make sure it is in
the ON position.
Power on the TV by
pressing the Power button
on the remote control.

Tuning Channels

Press the power button on the remote to turn
on the TV. After a brief delay, you will be
presented with a dialogue to help you
automatically tune available channels.

Front Panel Overview

The buttons on the lower-right hand panel control your TV's basic features,
including the on-screen menu. To use more advanced features, you must use the
remote control.

1. STANDBY BUTTON
Press this button to toggle between ON and STANDBY modes.

2. VOLUME CONTROLS
Press to increase or decrease the volume. Also used as left/right arrows in the on-screen menu.

3. PROGRAM CONTROL
Press to change channels. Also used as up/down arrows in the on-screen menu.

4. MENU
Press to see an on-screen menu of your Televisions features.

5. TV/AV
Toggles between all available input sources.

6. REMOTE CONTROL SENSOR
Aim the remote control towards this point on your television.

7. POWER INDICATOR
Red: In STANDBY mode.
Green: In power ON mode.

8. POWER SWITCH
Press this to allow your television to use electricity to power up.
Note: This button MUST be pressed for the television to work.

9. 3D SYNC SIGNAL EMITTER
Sends out the sync signal for 3D shutter glasses.