Kogan NBJEPWGCRDA, NBJEPWGCWHA User Manual

KIDS RIDE-ON CAR

(JEEP-WRANGLER-INSPIRED)

NBJEPWGCRDA & NBJEPWGCWHA

-

Ensure you have read and fully understood all these instructions. Retain this user guide for
future reference.

• The product should be assembled correctly by an adult before use.

• Ensure all packing materials are discarded and kept away from children.

• The car contains small components which is not suitable for children less than 3

years old.

• Check the car, the charger, the plug, all electric wires, the outer casing and other
components regularly for any evidence of damage. Stop operating the car
immediately if it is damaged.

• Ensure the battery is connected with the correct polarity.

• Ensure the battery is fully charged for 15 hours before using the car for the first time

otherwise the battery may be damaged permanently.

• During use if the driving speed of the car slows down significantly, charge the car
immediately. It should be fully recharged in 8-10 hours (do not exceed 15 hours).

• Charging should only be performed by an adult. Do not let children play with the
charger.

• When charging, insert the charger into the car charging port before plugging the
charger into the power outlet. When the vehicle is charging, the car cannot be
operated.

• Ensure all cable connections are secure before charging.

• Ensure the charger and connectors are dry before charging to avoid a short circuit.

• Do not modify the cars structure or electrical system in any way.

• It is normal for chargers and batteries to heat up during charging.

• Do not use the car in dangerous places such as the public roads, streets and any

place with obstacles.

• Keep the car and remote control away from water, fire and other sources of heat.

• Do not operate the car if it is raining or snowing outside.

• Avoid driving on smooth surfaces such as marble, tiles or glass.

• The maximum occupancy of the car is one child. The maximum load capacity is

30kg.

• Fas ten the s eat bel t an d ensure your child always sits in the car. Do not let your
child stand or perform dangerous actions while driving.

• Ensure the seat belt is used while driving.

• Do not suddenly switch the forward/backward button while the car is in motion.

• Avoid driving in narrow spaces to prevent damage to the car and your property.

• Tu r n o f f t h e p o w e r s u p p l y a n d u n p l u g t h e b a t t e r y c o n n e c t o r i f y o u are not using the

car for an extended time.

• Children should always be supervised and within 10 metres of an adult when
driving the car.

• The remote control must be operated by an adult.

• When the power of the remote control is insufficient, the vehicle will be only able to

move forward and backward and not turn left or right. Stop use immediately and
replace the remote control batteries.

Car Body

Wheel (x4)

Wheel cover (x4)

Spare Wheel

Steering wheel

Front bump er

Windshield

Lightbar

Lightbar

stand (x2)

Side mirror (x2)

Seat

Remote control

Charger

Keys

Fas tene rs

WAR NIN G:

Do not use power tools to assemble the car and avoid overtighten the screws as this may
damage the plastic components.

During assembly be gentle with wheels, wheel covers and bumpers to avoid cracking them.

Step 1: Wheels

• Remove the pin and washers from the axle.

• Install wheel onto the axle.

• Place the washers back on the axle and secure in place using the pin.

• Install the wheel cover on the wheel ensuring the clip on the wheel cover lines up

with the holes on the wheel.

• Repeat for the remaining wheels.

Step 2: Steering wheel

• Attach the steering wheel connector to the mating connector on the car.

• Fee d the wire into the car and push steering wheel onto the steering rod until it is

securely in place.

Step 3: Fro nt bump er

• Attach the front bumper to the front of the car and fasten using the supplied
screws.

Step 4: Windshield

• Lift the bonnet and attach the windshield to the car.

• Secure the windshield using the supplied screws

Step 5: Lightbar

• Connect the lightbar connector to the mating connector on the lightbar stand.

• Attach both lightbar stands to the lightbar.

• Attach the assembled lightbar to car.

• Connect the lightbar stand connector to the mating connector on the car.

Step 6: Side mirrors

• Attach the two side mirrors to car body.

Step 7: Seat

• Remove the plastic cover from the battery and connect the battery wires to the
battery.

• Ensure all the connectors are secure and install the seat into the car.

• Secure the seat in place using the supplied screws.

Step 8: Spare wheel

Attach the spare wheel to the clip on the rear of the car.

Step 9: Remote control

• Remove the screw on the battery cover with a screwdriver and then remove the
battery cover, insert the x2 AAA 1.5V batteries.

• Refer to the operation section of this user guide for pairing instructions.

Using the car

1. Insert the keys into the ignition and turn on the cars power switch. The car will start
and the lights will turn on.

2. Ensure the seat belt is used while driving.

3. Switch the Forward/Backward button to the forward position and step on the pedal
to drive the car forward.

4. Switch the Forward/Backward button to the backward position and and step on
the pedal to drive the car in reverse.

5. Tu r n t h e power switch off when finished using the car.

If the car not being used for an extended period disconnect the battery. Ensure the the car is
recharged at least once a month.

Remote control

When using the remote control for the first time, you must pair the remote with the car.

1. Tu r n o f f t h e c a r ’ s p o w e r s w i t c h .

2. Ensure the x2 AAA batteries have been installed. The remote control’s LED will
flash slowly.

3. Tu r n o n t h e car’s power switch and the LED will turn solid when pairing is
successful.

4. Once pairing has is complete, there is no need to re-pair the remote control until
the batteries are replaced.

5. If the remote and car do not pair (the LED continues flashing), remove the batteries
and repeat steps 1-3.

6. The indicator LED will turn off 10 seconds after the last input to save power. It will
wake when any button is pressed.

Audio player

The car features an audio player with both AUX and USB ports for playing audio files. The
audio player has buttons to control volume, play/pause and skipping tracks. If nothing is
connected to the ports the car will play preset music and sounds.

Battery

12V 7Ah

Motor

12V 380 (x4)

Suitable age

3-6 years

Max load

30kg

Speed

0-6km/h

Use time

1-2 hours

Charing time

8-10 hours

Charger

12V

Remote control battery

AAA 1.5V (x2)

Dimensions

130x82x70cm

Need more information?

We hope that this user guide has given you

the assistance needed for a simple set-up.

For th e mo st u p-to-date guide for your product,

as well as any additional assistance you may require,

head online to help.kogan.com