Kogan KGNBD2A Instruction Manual



TABLE OF CONTENTS

SAFETY PRECAUTIONS

IMPORTANT SAFETY INSTRUCTIONS

NOTICE

PLAYABLE DISCS

ACCESSORIES AND PANEL

REAR PANEL

BASIC CONNECTION

REMOTE CONTROL

BASIC PLAYBACK

ADVANCED PLAYBACK

SPECIAL FUNCTION PLAYBACK

SYSTEM SETUP

FREQUENTL Y ASKED QUESTIONS

TROUBLE SHOOTING

SPECIFICATIONS

SAFETY PRECAUTIONS

This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.

Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories.

Manufactured under license under U.S. Patent #’s: 5,451,942; 5,956,674;5,974,380; 5,978,762;6,226,616;6,487,535 & other U.S. and worldwide patents issued & pending. DTS is a registered trademark & the DTS logos and symbol are trademarks of DTS, Inc. 1996-2007 DTS, Inc. All rights reserved.

Disposal of your old appliance

1. When this crossed-out wheeled bin symbol is attached to a product, it means the product is covered by the European Directive 2002/96/EC.

2. All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities.

3. The correct disposal of your old appliance will help prevent potential negative consequences for the environment and human health.

4. For more detailed information about disposal of your old appliance, please contact your city office, waste disposal service or the shop where you purchased the product.

PLAYABLE DISCS

Features

Full high-definition video playback at up to 1080p resolution for an amazing viewing experience. Upconversion of standard definition DVDs for enhanced picture quality at up to 1080p over an HDMI connection. Rich multi-channel surround sound. Easy and simple HDTV connection using a single HDMI cable (cable not included). Multiple outputs for connecting your home theater system or amplifier. PIP functionality that lets you display primary and secondary video at the same time (if available on the Blu-ray Disc). Pop-up menu display without interrupting playback (if available on the Blu-ray Disc). HDMI 1080p/fps output (Blu-ray Disc only) that provides smooth playback of video with a frame rate of 60 frames per second (TV must be connected with an HDMI cable and be compatible with an HDMI cable and be compatible with 1080p 60 frame).

The following types of discs can play in the REF player:

Disc type

Blu-ray Disc DVD-video Disc

(DVD-ROM) Audio CDs

(CDDA) DVD-RAM

DVD-RW DVD+RW

Logo

Disc type

DVD-R DVD+R

MP3/WMA/JPEG Data CD

MPEG4

DivX

CD-R

Logo

CD-RW

Notes:

Writeable DVD disks (DVD-RAM, DVD-RW, DVD-R) must be finalized, VR-mode only. This Blu-ray disc player supports discs that are compatible with DVD-RAM Standard Version 2.0. Playback may not work for some types of discs, or when specific operations, such as angle change and aspect ratio adjustment, are being performed. Information about the discs is written in detail on the box. Please refer to this if necessary. Do not allow the disc to become dirty or scratched. Fingerprints, dirt, dust, scratches or deposits of cigarette smoke on the recording surface may make it impossible to use the disc for playback. CD-R/-RW, DVD-RAM/-RW/-R recorded with UDF or ISO9660 format can be played back. Windows Media Audio (WMA) files must be written to the disk with a .wma file extension in order to be recognized and played back properly. High bitrate or variable bitrate .wma files may not play back correctly. JPEG picture files must be written to the disk with an .jpeg or .jpg file extension in order to be recognized and played back properly

FRONT PANEL

STANDBY/ON

ACCESSORIES and PANEL

OPEN/CLOSE PLAY/PAUSE

USB

STOP

NEXTPREV

8 9 10

1. STANDBY/ON Turns the Blu-ray disc player on or off.

2. TRAY Opens to accept a disc.

3. OPEN/CLOSE Opens or closes the disc tray.

4. VFD SCREEN Display the playing status, time, etc.

5. REMOTE CONTROL SENSOR Receive the signal from the remote control.

6. PLAY/PAUSE Play: playback a disc; Pause:

7. STOP

Stop playback.

Temporarily pauses BD disc playback.

8. PREVIOUS Go back to the previous title/chapter/track.

9. USB Connect a USB drive to this jack.

10. NEXT Go to the next title/chapter/track.

ACCESSORIES

Batteries......................................

Audio/Video cable .....................

manual ...............................

User

Remote control ..........................

2 1 1 1

USER MANUAL

STANDBY/ON

DISC MENU

SETUP

RESOLUTION PIP

1 2

REPEAT

OSD

AUDIO

A B C D

OPEN/CLOSE

8 9

RETURN

A-B

SUBTITLE

ANGLE

POPUP MENU

TITLE MENU

ENTER

VOL

SECONDARY

MUTE

AUDIO

USER MANUAL

REAR PANEL

REAR PANEL OUTPUT

Blu-ray

CENTER

SUB-WOOFER

7.1-CH AUDIO OUT VIDEO OUT / AUDIO OUT

VIDEO

Y CB / PB CR / PR

1. POWER LINE INPUT Isolates Mains supply

2. ANALOG 7.1 AUDIO OUTPUTS Connect these outputs to the analog inputs of a surround sound speaker. (If surround sound speaker is 5.1 channel, leave the surround channels disconnected).

3. Y, CB/PB, CR/PR OUTPUT Connect these outputs to the YUV inputs of the television, if the television does not have an HDMI input. NOTE: The component video output has a maximum resolution of 1080i.

4. VIDEO OUTPUT If your TV does not have component or HDMI video inputs, connect this output to the composite video input of the HD television.

5. L/R AUDIO OUTPUT onnection for external equipment using the Red/White Audio (RCA) Cables.

C 6

. HDMI OUTPUT If your surround-sound audio receiver does not have an HDMI input (or if you are not using a surround-sound receiver), connect this output directly to the HDMI input of the TV. One of the other audio outputs can be connected to the audio receiver. Otherwise, connect the HDMI output of the player to the HDMI input of the audio receiver. (You will need to connect a second HDMI cable from the HDMI output of the audio receiver to the HDMI input of the television)

7. ETHERNET INTERFACE

8. OPTICAL OUTPUT This is another digital audio output. If you have a surround-sound receiver with a digital optical input, connect this output to the digital optical input of the surround sound receiver.

9. COAXIAL OUTPUT This is a digital audio output. If you have a surround-sound receiver with a digital coaxial input, connect this output to the digital coaxial input of the surround sound receiver.

DVD-Video

ETHERNET

HDMI

COAXIAL

OPTICAL

DIGITAL AUDIO OUT

WARNING

Disconnect the unit from the mains before removing the cover.

This unit plays only the discs with the same regional code as the unit or discs with no regional code. Please check whether both the BD player and the disc have the same regional code before playback.

CLASS 1 LASER PRODUCT

BLU-RAY DISC PLAYER

MODEL: KGNBD2A AC: 110V-240V~ 50/60Hz

S/N:

POWER: 25W

MADE IN CHINA

CAUTION

RISK OF ELECTRIC SHOCK DO NOT OPEN

Manufactured under license under U.S. Patent #’s: 5,451,942; 5,956,674;5,974,380; 5,978,762;6,226,616; 6,487,535 & other U.S. and worldwide patents issued & pending. DTS is a registered trademark & the DTS logos and symbol are trademarks of DTS, Inc. 1996-2007 DTS, Inc. All rights reserved.

U.S. Patent Nos. 6,836,549; 6,381,747; 7,050,698; 6,516,132; and 5,583,936.

Dolby and the double-D symbol are registered trademarks of Dolby Laboratories.

This product is covered by one or more of the following U.S. Patents: 5,060,220 5,457,669 5,987, 417 6,377,524 6,389,570 6,556,5206,631,110 6,778, 755 6,795,637 6,862,256 6,868,054 6,937,552.

73 4 5 6 981 2 10

Region codes:

If the Region number of a BD or DVD disc does not correspond to the Region number of this Blu-ray disc player, the Blu-ray disc player cannot play the disc. The region code is called out on the rear panel of the BD player.

+ 19 hidden pages