M8 PRO CORDLESS 22.2V STICK
VACUUM CLEANER AND MOP
KAVACSTM08A
SAFETY & WARNINGS
When using an electrical appliance basic safety precautions should always be followed
including the following:
• Read all instructions.
• Do not use near stairs or on balconies. This appliance does not have a “no
avoidance” sensor.
• Children aged 8 years and above or persons with reduced physical, sensory or
mental capabilities should only use this appliance while under supervision or
instruction from an adult or carer.
• Children aged 8 and above should not clean or perform user maintenance on this
appliance unless under supervision or instruction from an adult or carer.
• This appliance is intended for domestic use only.
• This appliance is suitable for low to medium felt back carpets. It is not suitable for
uneven floors or mixed carpets.
• Do not operate any appliance with a damaged or abnormal cord or plug. If the
main cord is damaged, it must be replaced by Kogan.com or a service agent on
Kogan.com's behalf.
• Recharge the battery using only with the charger supplied with the appliance.
• Do not use this appliance with any other battery other than the one supplied. The
use of any other battery could cause an explosion or fire.
• Do not use on wet or greasy surfaces.
• Before use, remove any objects that could entangle the brushes (long hair, plastic
bags, rope, wire, etc.).
• Do not sit on the appliance or place heavy objects on it.
• Ensure there is no obstacles in the room which the vacuum may tip and create a
hazard (such as lit candles or a vase filled with water).
• Regularly clean the machine.
• Empty the dust tank after every use.
• When not in use for more than two months the vacuum cleaner should be
disconnected from the power supply. Ensure the battery is charged prior to
disconnecting the power. To e n s u r e a l o n g e r s e r v i c e l i f e , t h e v a c u u m c l e a n e r m u s t
be charged once every two months.
• Only recharge the vacuum when alerted by the low power alarm or when the
power is turned off. The appliance will be ready for use after it is fully charged.
• The battery must be removed from the vacuum prior to its disposal. The appliance
must first be disconnected from the power outlet before removing the battery.
• Do not dispose of batteries with household waste. Dispose of them in accordance
with your local regulations.
• The cable on the Power adapter cannot be replaced if damaged. Instead the
Power adapter must be replaced by Kogan.com or a service agent on Kogan.com's
behalf.
• This appliance contains a non-replaceable battery.
Power adapter
• WARNING: The Power adapter must be removed from the power outlet before
cleaning or performing any maintaining on this appliance.
IMPORTANT:
• Do not attempt to replace the power cable by yourself if damage. The Power
adapter must be replaced by Kogan.com or a service agent on Kogan.com's
behalf.
• If the device is dropped, please contact Kogan.com to check it before using it
again. Internal damage could cause accidents. For any kind of problems or repairs,
please contact Kogan.com.
Disposal and environmental responsibility
Contact your local authorities or recycling centres for more information.
1
Detachable battery pack
11 Floor brush release button
2
Ergonomic handle
12 Floor brush
3
Indicator lights
13 Crevice head
4
Outlet filter cover
14 2 in 1 brush head
5
Dust tank
15 Wall mount with removable sticker
6 Dust tank release button
16 Floor brush switch
7
Metal tube release button
17 Power level buttons (3 levels)
8
Metal tube
18 Power button
9
Accessory support
19 Battery
10 Power adapter
20 Water tank
OVERVIEW
Metal Tube
1. Insert the metal tube into the main body until a ‘click’ sound is heard.
2. Press the metal tube release button and remove the tube.
Floor Brush Installation
1. Insert the floor brush on the end of the metal tube until a ‘click’ sound is heard.
2. Press the floor brush release button to remove the floor brush.
Note:
The floor brush, crevice head and 2 in 1 head can be directly connected to the main
body or metal tube.
Wat er Tan k I nst all at ion
1. Position the cloth to the base of the water tank.
2. Attach the water tank with floor nozzle, keep the magnetic cells both on nozzle
base and water tank together.
3. Fill the water tank with water.
Dust Tank Installation
1. Insert dust tank into the main body and twist counter-clockwise until a ‘click’ sound
is heard.
2. Holding the opening part connected to the tube, twist clockwise to remove it.
Battery Installation
1. Install the battery into the bottom of the main body until a ‘click’ sound is heard.
2. Press the battery release button to remove it.
Ensure all packing material around the appliance and the protective elements
inside the appliance compartments are removed prior to first use.
Charging Port
Note:
• Charge the battery before the first use.
• It is recommended to fully charge the battery for the first 3 uses.
• Do not charge the battery for extended periods, as this may damage
the battery.
Before First Use
Unpack the appliance and any accessories. Dispose of the packing materials.
• Carton board and the sheets of paper included are recyclable. They must be
disposed of in the appropriate recycle bin.
• Materials bearing the symbol are recyclable:
PE = Polyethylene; PS = Polystyrene; PP = Polypropylene
They must be disposed of in the appropriate recycle bin.
• Any other packaging material (adhesive, fasteners, etc.) must be disposed of with
regular household waste.
Charging
Plug the power adapter into the charging port on the Vacuum main body and then plug the
adapter into the power outlet.
Indicator Lights (All green colour)
Status Sequence
Indicator Lights
During charging
Charging from low to high: lights
will flash sequentially until all
three lights are on (fully
charged).
Fau lt
All three lights flashing at the
same time, please check if the
brush roller is stuck or contact
Kogan.com.
During discharging or
use
Discharging from high to low,
lights flash sequentially until last
light flashing.
Out of power
Last light flashing until power
off, please charge.
Cleaning Accessories
• Floor brush: Suitable for rugs and hard floors. Turn it on/off by pressing the floor
brush switch.
• Crevice head: for cleaning corners, gaps, baseboard edges and other hard-to-reach
places.
• 2 in 1 brush head: Use this brush to clean upholstered surfaces, keyboards, lamps,
curtain, blinds, vents, etc. Perfect for cleaning hair and dust on fabric. Use the
crevice portion for the normal cleaning tasks. To switch between brush and crevice
portion, press the button on the accessory and slide brush head up or down.
Setting the Power Level
• Select the appropriate accessory for your cleaning task.
• Press the power button, the vacuum will switch on. Press the power button again to
switch it off.
• Press the ‘+’ or ‘-’ power level button to adjust between the three suction power
levels.
Emptying the Dust Tank
• Press the dust tank release button to empty the dust when finished cleaning.
• Close the dust tank cover when it is empty.
Magnetic wall mount
This appliance features a magnetic wall mount and does not require the bracket to
be screwed to the wall.
1. Ensure the bottom line of removable gel sticker is 940mm from to the floor, stick it
Note:
Clean the dust tank and filters monthly to maintain the performance.
to a clean vertical surface (wooden, ceramic etc.) (the gel sticker is washable).
2. Adhere the magnetic wall mount to the gel sticker.
3. Place the appliance on to the magnetic holder.
Cleaning the Dust Tank and Filters
1. Holding the opening part connected to the tube, twist clockwise to remove it.
2. Lift out the filter cover and separate the HEPA filter from the filter cover by twisting
Clockwise to lock
Counter-clockwise to unlock
counter-clockwise and pulling out.
3. Clean the dust cup and filters under running water.
4. Ensure the filters are completely dry before reassembling.
Post-Motor Filter Cleaning
Note:
Clean the post-motor filter every 6 months.
1. Rotate the filter cover counter-clockwise to remove it.
2. Lift out the post-motor sponge filter.
3. Shake to remove dust. Wash the filter under cold running water.
4. Ensure the filter is completely dry before reassembling.
Floor Brush Cleaning
1. Using a coin press down and turn the fastener counter-clockwise to unlock.
2. Remove any hair and debris around the brush roller.
3. Wash the brush roller under running water.
4. Ensure the brush roller is completely dry before reassembling.
5. To r e a s s e m b l e , i n s t a l l t h e b r u s h r o l l e r i n s i d e t h e o r i g i n a l p l a c e . U s ing a coin press
down and turn the fastener clockwise to lock.
Wat er Tank Cloth Cleaning
1. Wash the cloth under running water.
2. Ensure the cloth is completely dry before assembling.
3. Keep water tank separate from the nozzle after scrubbing the floor to avoid
dripping of water.
This marking indicates that this appliance should not be disposed with
other house-hold wastes. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources.
Power supply
Rechargeable battery
Motor max. power
200W
Battery
Li-ion DC 22.2V 2000mAh
Charging time
Max. 4-5 hours
Capacity of the dust tank
0.6L
Speed levels
3 speeds
Product Dimensions
240 x 220 x 1100mm
Net weight
3.0kg
Disposal
Battery charging signal:
1. Charging the battery may take you longer than usual under the following
circumstances:
a) Room temperature is higher than 30°C
b) Charging immediately after the vacuum cleaner has stopped operating.
2. Always recharge the vacuum cleaner after each usage no matter how long it has
been used.
3. Unplug the power adapter when not charging.
4. When not in use for more than two months the vacuum cleaner should be
disconnected from the power supply. Ensure the battery is charged prior to
disconnecting the power. To e n s u r e a l o n g e r s e r v i c e l i f e , t h e v a c u u m c l e a n e r m u s t
be charged once every two months.
5. The vacuum cleaner or power adapter may become hot during charging so take
the necessary precautions to avoid contact.
Problem
Solution
No power
Before using the appliance, check that it is fully charged,
empty the dust tank and clean the filters.
Loss of suction
Check to see if the openings are clogged. Unplug and clean
if necessary.
Make sure the filters are correctly installed. Empty the dust
tank and clean the filters.
The floor brush does not
turn
Unplug the unit, check for clogged hair or dirt. If necessary,
remove the rotating shaft from the floor brush by unlocking
the latch, clean and reposition the shaft by performing the
reverse procedure.
Make sure that the axle has been properly inserted into the
floor brush and the latch is in the locked position.
The appliance may need to be recharged. Connect the
device to the charger. The battery indicator will turn GREEN
when charging is complete.
The battery indicator
lights flicker while in use
The floor brush is blocked. Turn off the vacuum and remove
any object blocking the brush.
TROUBLESHOOTING
If you encounter a problem with your device or if you suspect the device is not working
properly, you can make a few simple checks before contacting Kogan.com.
For an y oth er pro blems occurring in yo ur devic e: cont act Kogan.com.
CAUTION: The floor brush contains electrical connections, do not immerse in water for
cleaning.
Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For th e mos t up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com
Loading...