Kogan KAMTRTGRNSA User Manual

MOUNTABLE RETRACTABLE
GREEN SCREEN

CHROMA KEY PANEL BACKGROUND

KAMTRTGRNSA

Note:

• Select the appropriate mounting hardware according to your chosen
mounting location.

• It is recommended to use a spirit level to ensure the screen is installed
straight.

• The load-bearing capacity of the screw in the wall/ceiling needs to be at
least 7kg per side.

When not in use, keep this screen rolled up in its protective case. Always examine both the
front and rear of surfaces of the screen before rolling it up to ensure it is free of dust, dirt or
other foreign matter. Use a very soft duster to gently remove any foreign particles.

Flush Wall Mounted (additional hardware required)

1. Using a tape measure, mark the keyholes that are located at the back of the
screen case end caps.

2. Predrill the holes, insert the screws, leaving the screw head out approximately
4mm (1/8”) from the wall to mount the screen on. (Figure 1)

Figure 1

Ceiling Mounted (additional hardware required)

1. You can also hang the screen from a ceiling by using a chain with s-hooks (not
included) through the two loops located on each end of the (Figure 2).

Figure 2

Regardless of mounting method, the screen should be securely supported so that vibration
or excessive pulling on the viewing surface will not cause the case to loosen or fall. The
installer must ensure that the fasteners used are of adequate strength and suitable for the
mounting surface chosen.

Note:

An internal auto-lock mechanism system will cause the screen to stop and lock on the
desired position at intervals.

Note:

Improperly bringing the screen up or down will damage the screen material or rolling
mechanism.

Note: Always pull the screen down or retract either at a steep incline or a 90-degree vertical
angle. Do not allow the screen to touch the case while opening or retracting to avoid
damaging the screen material.

Figure 3

1. Pull the screen down using the lanyard or by the handle at either a sharp incline or
a 90-degree angle. Do not pull the screen down by its material or touch the
screen, as it will cause damage and likely void the warranty. (Figure 3)

2. If you want the screen to retract back into the case, simply pull the screen down
more than 5cm (2”) and retract the screen back, guiding the material in a gentle
motion.

Clean the screen material using a soft cloth and mild soapy water. When not in use, retract
screen in its housing to keep the surface clean.

Need more information?

We hope that this user guide has given you

the assistance needed for a simple set-up.

For the most up-to-date guide for your product,

as well as any additional assistance you may require,

head online to help.kogan.com