Page 1
.$+76,5;$
USER MANUAL
Page 2
Thank you for purchasing the Kogan 1800W Outdoor Radiant Strip Heater.
Please read these instructions carefully before operating the product.
Why choose a Radiant Strip Heater over a conventional patio heater?
Conventional heaters function by heating the air around them, which is often then
dissipated due to wind and surrounding low temperatures. This can often result in
uncomfortably hot temperatures close to the heat source and leave the rest of the area
still in the cold.
Radiant style heaters transfer heat directly to people and surfaces via infra-red waves,
meaning that the warmth penetrates through the air, providing a comfortable even
temperature.
Performance Features
Comfort: No moving air currents, light or odour will emanate from the unit, so you
will not have dust or other airborne particles disturbed.
Energy Efficient: Once the unit has heated up to the desired temperature, instead of
having to keep burning energy at that level like an electric bar heater or a gas flame,
the radiator heater simply maintains the heat at that level with minimal heat loss.
Working Conditions
Ambient temperature: -30C ~ +30C
Rated Voltage: 220-240V~
Rated Frequency: 50Hz/60Hz
Relative Humidity: less than 95%
Installation Requirements
Qualified installer: The installation should be performed by professional installation
personnel with an electrical installation certificate and it must meet the national
electrical safety standards.
• Installation conditions:
Supply voltage fluctuation range should be within ±10%. If this is not met, the
power supply should be revised prior to installation.
• If there is a serious security risk in the users' electricity environment,
installation should be refused until the risk has been eliminated.
• Electricity lines should be equipped with earth leakage protection devices and
a master safety switch.
Page 3
• Ground wire should be connected to the grounding device on the building. If
not, please consult a professional installer. Do NOT put ground wire to a gas
pipe, water pipe, lightning rod or telephone grounding line.
Electrical Parameters Comparison Table
Model No. Power (W) Rated Current (A) Voltage (V) Wire length (mm)
ZB-10A 1000 4.3 220-240 2000
ZB-18A 1800 7.8 220-240 2000
ZB-24A 2400 10.4 220-240 2000
ZB-32A 3200 13.9 220-240 2000
Installation Instructions
Page 4
Page 5
Installation Diagram
Page 6
Internal Wire Diagram
Page 7
Wire Diagram
Inspection Items after Installation
Items to be checked Situation caused by improper installation
Is installation stable? The equipment may fall off or shake.
Is heat insulation adequate? Objects close to heater may be damaged.
Does voltage match voltage on nameplate? Equipment failure.
Is the wire connection correct? Equipment failure.
Does electricity ground safely? Electricity leakage risk.
Does wiring conform to national standards? Equipment failure or circuit damage.
Page 8
Inspection Items for Commissioning
• Do not turn on power before the installation is entirely complete.
• All wire connections must be correct and stable.
• All scattered objects and tools must be removed from the heater body.
• Connect unit to power and observe it working for a duration before leaving it
operating unattended.
Safety Precautions
• Do not use the same power socket to power other appliances in case of current
overload. Make sure the plug and the socket are making good contact.
• Please disconnect power supply when powering off for an extended period of
time.
• Please stop power immediately in the case of the heater failing or wires
breaking. Users can not repair the heaters themselves. Please contact the
Kogan Customer Support team for warranty and repair advice.
• Radiant heater must not be placed directly below the power outlet.
• The surface of the heater will get extremely hot. It must be installed higher
than 2.2 meters above the ground.
• The heater must not be covered and can not be hung off other objects or
equipment.
• The distance between the back of the heater and the roof should be larger than
150mm and the sides should be kept 200mm away from other surfaces. Do not
place anything within 1 meter of the front of the heater.
• Power must be turned off and the surface allowed to cool prior to cleaning.
Flushing unit with water is prohibited.
• Users cannot repair the heater. Please contact the Kogan Customer Support for
maintenance or repair requirements.
• Do not install or use the heater in areas with flammable or explosive items
nearby.
• Please do not insert any metal or foreign objects into the heater.
• The panel surface of the heater can reach temperatures between 250C ~ 380C.
Touching the surface is forbidden and children MUST be supervised when
heater is in use.
• Do not splash water into the heater under any circumstances.
Page 9
Packing List
NO. Name QTY
1 Heater 1 pc
2 Adjusting Bracket 4 pc
3 Sliding Bracket 1 pc
4 Fastener 1 set
5 Certification 1 pc
Specifications
Model Dimension(mm) Package Size(mm) Net Weight (kg) Gross Weight (kg)
ZB-10A 600*189*67 680*250*145 3.7 4.8
ZB-18A 1000*189*67 1080*250*145 6.2 7.4
ZB-24A 1500*189*67 1580*250*145 8.8 10.6
ZB-32A 2000*189*67 2080*250*145 11.6 13.6
Loading...