Kogan HD26 Instruction Manual

High Definition LCD TV

Kogan HD26

USER MANUAL

Safety information

To ensure reliable and safe operation of this equipment, please read carefully all of the instructions in this user guide, especially the safety information below.

Electrical safety

·The TV set should only be connected to a mains power supply which matche s that stated on the label on the mains power adaptor.

·To prevent overload, don’t share the same mains power supply socket with too many other items of equipment.

·Be careful to route the mains power cable away from areas where people can trip over it.

·Unplug the TV when it is not going to be used for a long time. Disconnect both the

aerial and the main power cable.

·Take care not to expose the TV set or the remote control to water or moisture.

·Pull the plug out immediately, and seek professional help if:

- the mains power plug or cable is damaged

- liquid is spilt onto the TV set, or if it is accidentally exposed to water or moisture

- anything accidentally penetrates the ventilation slots

- the TV set doesn’t work normally.

·Never remove the cover, there are no user-serviceable parts inside. Allow only qualified service personnel to repair this equipment.

·To avoid leakage, take out the remote control batteries when:

- the batteries are exhausted

- you are not going to use the remote control for a long time.

·Batteries should be recycled or disposed of in a proper manner.

Physical safety

·Make sure the set is positioned at least 5cm (2inch) from the wall or furniture.

·Never tap or shake the screen for any reason.

·Take care not to drop or sit on the remote control.

·Clean the set using only a soft, clean, dry cloth. Do not use any solvents.

OPERATING INSTRUCTIONS

Contents

Safety information--------------------------------------------------------------------------------------- 1

Electrical safety ------------------------------------- ---------------------------------------------------- 1

Physical safety --------------------------------- ------ ------ ---- ------ ------ ---- ------ ---- ------ ------ --- 1 In the box -------------------------------------------------------------------------------------------------- 3 Connection ------------------------------------------------------------------------------------------------ 4 Rear connection panel -------------------------------------------------------------------------------- 4 Getting Started ---- ---- -- ---- -- -- ---- -- ---- -- -- ---- -- ---- -- -- ---- -- ---- -- -- ---- -- ---- -- -- ---- -- ---- -- -- --- 5

Front panel controls ------------------------------------------------------------------------------------ 5 The Remote control ------------------------------------------------------------------------------------- 6

Using the remote control for normal TV functions ---------------------------------------------- 6 Initial Setup Instruction Guide ---------------------------------------------------------------------- 8 Power ON/OFF: Standby mode -------------------------------------------------------------------- 8 Selection of Input Mode ------------------------------------------------------------------------------ 8 On Screen Display (OSD) Menu -------------------------------------------------------------------- 9 Navigating the OSD Menu--------------------------------------------------------------------------- 9 Video Page Menu -------------------------------------------------------------------------------------- 10 Audio Page Menu -------------------------------------------------------------------------------------- 13 TV Page Menu (Only for TV) ------------------------------------------------------------------------ 14 Setup Page Menu -------------------------------------------------------------------------------------- 17 Parental Page Menu ---------------------------------------------------------------------------------- 19 Troubleshooting ------------------------------------------------------------------------------------------ 22 Maintenance ----------------------------------------------------------------------------------------------- 23 Features and Specifications-------------------------------------------------------------------------- 24

In the box

TV set

Power supply cable Remote control

- If any of the accessories are missing, then please contact Kogan Technologies.

- Keep all the original packaging in case you need to return the TV to Kogan Technologies.

Connection

Rear connection panel

Number Name Function Description

1 HDMI HDMI input jack (audio and video) 2 VGA VGA (D-sub) comp uter input 3 VGA Audio IN VGA audio input (3.5mm stereo) 4 YPbPr (1,2) IN YPbPr inputs 5 YPbPr (1,2) Audio IN YPbPr Audio input 6 S-VIDEO S-Video input 7 COAX OUT Audio signal (digital) coaxial output 8 CVBS IN AV analogue video input

9 CVBS_R/CVBS_L AV analogue audio input (also S-Video audio IN) 10 CVBS OUT This port is not functional on this model 11 CVBS Audio OUT This port is not functional on this model 12 RF Connect to TV cable/antenna or DVB -t antenna 13 AC Connect to the supplied Power Adaptor 14 TEST USB slot for testing and upgrade

Getting Started

1. Connect the aerial or input source to the appropriate input socket at the rear of the TV set (see page 4).

2. Connect the small round plug on the power adaptor cable to the power input socket at the rear of the TV set.

3. Connect the power cable between the power adaptor and the mains supply.

4. Turn on the TV Power switch under the right hand speaker.

5. Switch the TV on by pressing the POWER button on the front panel or the remote control (the LED will show green).

6. Use the AV/TV button on the front panel or the remote control to select which input source to use : TV-AV-SVIDEO-YPBPR1-YPBPR2-VGA-HDMI

7. You can use the front panel controls to adjust the volume or select a channel as shown below, or you may use the remote control for these functions.

8. To switch the set off for a short time, press the POWER button, the set will go into standby and the LED will show red. If you are not going to use the set for some time, switch the power off completely by unplugging the mains cab le.

Front panel controls

The Remote Control

Using the remote control for normal TV functions

1. Insert two AAA batteries, making sure that the polarity is correct as marked inside the compartment.

2. Aim the remote control at the IR sensor just below the green light (see page 5 for diagram). Keep this area clear at all times.

3. Do not press the buttons on the remote too quickly – allow the TV time to respond.

01. POWER :

02. MUTE :

03. DISPLAY: Press to show or remove status display

04. VOL+: Press to increase volume

05. VOL-: Press to decrease volume

06. Numbers: Press to select a channel

07. AV/TV: Press to select input source

08. PMODE: Press to select picture display mode.

09. Enter: Press to confirm your sele ction

10. Directions: Press to Select up (Page+ for TV

11. LCD Menu Press to display the LCD Menu system (see p.9) 12, 13, 15.: These buttons are unused on this model

14. SUBTITLE Press this button to activate subtitles for Digital

16. A/E Press this button in TV mode to make the

17. FAV: Press this button to enter the Favourites menu

18. TIMER: Press to display the time

19. SLEEP: Press to enter Sleep mode, where the TV will

20. GREEN Press to activate the “GREEN” function in

21. RED Press to activate the “RED” function in teletext

Press to enter or exit the standby mode Press to turn on or off speaker output

teletext), down (Page- for teletext), left, and right in menu screens.

TV programs where available.

current channel a Favourite

directly

automatically enter standby mode after a set time (press to toggle between “Off” and up to 240 minutes in 15 minute increments)

teletext

22-23.: These buttons are unused on this model

24. CH+ Press to select TV channel (see p.15 “Channel Skip”)

25. CH- Press to select TV channel (see p.15 “Channel Skip”)

26. DOT Press the number buttons with this to select channels directly (i.e. channel 108-1 would need the DOT button pressed after the 8).

27. SMODE Press this button to toggle between preset sound modes for different echoing effects.

28. EXIT Press this button to exit in a menu.

29. TEXT Press to enter or exit teletext mode for TV/DVB

30-32.: These buttons are unused on this model

33. EPG In TV/DVB mode, press to display the Electronic Programming Guide

34. Press to access subpages for teletext

35. This button is not used on this model

36. Press to toggle between available display aspect ratios for the current input.

37. YELLOW Press to activate the “YELLOW” function in teletext

38. BLUE Press to activate the “BLUE” function in teletext

Note: The TV will return to TV mode when any of the buttons for changing channels are used, i.e. the Number buttons, CH+ and CH-

+ 17 hidden pages

Kogan HD26 Instruction Manual

Specifications and Main Features

Frequently Asked Questions

User Manual