Kogan CTMINCRACTA User manual

MINI CORDLESS AIR COMPRESSOR TYRE INFLATOR
CTMINCRACTA
SAFETY & WARNINGS
Read all of the following instructions before use. Keep this user guide for future reference.
Keep the product away from flammable or explosive materials.
Do not leave the inflator unattended while inflating. After 8 minutes of continuous
use, the inflator must be stopped for the next 8 minutes.
If there is abnormal noise or the temperature is too high during inflation, cease use immediately. Allow the inflator to cool down for at least 15 minutes. Be cautious when disassembling, the inflator will be hot.
If the inflator is not used for a long time, ensure to store it in a dry and closed place. For long-term storage, it is recommended to charge it once every 3 months.
Before using the inflator, check whether it has been charged. The first-time charging requires more than 4 hours for the inflator to be fully charged. After that, charge the inflator full until the charging indicator light emits green.
This inflator is equipped with a battery that can be used for cordless inflating.
Ensure to follow the instructions in this user guide to use the inflator and its
accessories.
Narrow Nozzle
Adaptor
Short Nozzle
Adaptor
Air Pump USB Charging Cable Car Charger
Inflation Hose
Needle Adaptor
1
2 3 4 5 6 7 8 9 10
11
12
OVERVIEW
1 Power Button
2 Setting Button
3 Increase Pressure Button
4 Decrease Pressure Button
5 LED Display
6 Air Pump Body
7 LED Emergency Lights
8 Air Outlet
9 Micro USB Port
10 Emergency Light Button
11 USB Reverse Charging Port
12 Car Charging Port
CONNECTION
Connect the inflation hose to the air outlet. As per your requirement, attach the included adaptors to the inflation hose:
Narrow Nozzle Adaptor: Suitable for swim ring, pillow, etc.
Short Nozzle Adaptor: Suitable for balloons, etc.
Needle Adaptor: Suitable for basketballs, footballs, etc.
After inflating, unscrew the adaptor by rotating counter-clockwise. Use caution as the adaptor might be hot. It is normal if there is a little air leakage when unscrewing the adapter.
Unscrew the inflation hose from the inflator, pack the inflator and place it in a dry, ventilated, and safe place.
Press twice
Blue light is on
Press three times
Red and Blue lights flash quickly
Press five times
Both Red and Blue lights are on
Press six times
Light is turned off
1. Press and hold the Power Button for 3 seconds to turn on the inflator.
2. Short press the Setting Button to select an air pressure unit: psi, bar, kPa, kg/cm
3. Short press the Increase Pressure Button to add once. Press and hold to keep increasing the air pressure.
4. Short press the Decrease Pressure Button to decrease once. Press and hold to keep decreasing the air pressure.
5. When adjusting the air pressure value, the lights will flash and after the flash stops, press the Power Button to start inflating. When the inflation pressure reaches the pressure value you set, the inflator will automatically stop inflating immediately.
6. To turn on the Emergency Light Button at night, do the following:
Press once Red light is on
Press four times Red and Blue lights flash slowly
2
.
7. To turn off the air pump, press and hold for 3 seconds.
8. To use the USB reverse charging mode:
Ensure the air pump is turned off.
Plug in a USB cable into the USB Reverse Charging Port, press the Power
Button for 3 seconds to enter the reverse charging mode. It will automatically stop when your device is fully charged.
Input Voltage
Charger 5V/2A
Working Current
1-5A
Car Power Input
12V 3A
Charging Method
Micro USB
Charging Time
About 4 hours
Battery Capacity
2000mAh
Emergency Light Duration
Up to 6 hours
Working Temperature
-20°C~70°C
psi: 150
bar: 10.3
kPa: 990
kg/cm2: 10.5
Product Size
170x60x45mm
Product Weight
590g
Maximum Pressure
NOTES
Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com
Loading...