
...C3...
Seite 2 ...C3... K01/0916
1. Contents
1. Contents ........................................................................................................ 2
2. Note .............................................................................................................. 3
3. Electrical Connection .................................................................................... 3
4. Programming ................................................................................................ 5
5. Maintenance ............................................................................................... 12
6. Technical Information .................................................................................. 12
Manufactured and sold by:
Kobold Messring GmbH
Nordring 22-24
D-65719 Hofheim
Tel.: +49(0)6192-2990
Fax: +49(0)6192-23398
E-Mail: info.de@kobold.com
Internet: www.kobold.com

...C3...
...C3... K01/0916 Seite 3
2.Note
This programming instruction is only a supplement to the operating
instruction for the sensor.
3. Electrical Connection
3.1. General
Attention! Make sure that the voltages in your plant correspond
with the instrument voltages
Make sure that the supply wires are de-energized.
Connect the supply voltage and evaluation of both output signals to the plug
connector PINs as shown in section 3.2 and 3.3.
We recommend the use of wires with cross sectional area of min. 0,25 mm²
Attention! Incorrect wiring will lead to damage of the unit’s
electronics.

...C3...
Seite 4 ...C3... K01/0916
3.2. Compact Electronics: (..C30R, ..C30M)
3.3. Compact Electronics: (..C34P, ..C34N)
Terminals 3 and 5 are linked internally and can therefore be used either for the
output signal or the power supply.
+ Vs
GND
GND
1
2
4
3
5
Switc h o u t 2
Switc h o u t 1
+ Vs
GN D
GN D
1
2
4
3
5
(0)4 -20 mA
Switc h o ut 1