Koala Kare KB112-01RE User Manual

KOALA KARE PRODUCTS

Installation and Operation Instructions

KB112-01RE Baby Changing Station

Cambiador Plegable

Table à Langer

Babywickeltisch

Your unit can be installed to meet ADA regulations when and where applicable. Refer to
Federal Register, Volume 56, No 144 28 CFR Part 36.

You are responsible for the safe operation of this unit.

IMPORTANT. RETAIN FOR FUTURE REFERENCE. READ CAREFULLY.
IMPORTANTE. GUÁRDELO PARA FUTURAS CONSULTAS. LEER ATENTAMENTE.
IMPORTANT. À CONSERVER POUR INFORMATION. À LIRE ATTENTIVEMENT.
WICHTIG. ZUR SPÄTEREN BEZUGNAHME AUFBEWAHREN. BITTE SORGFÄLTIG
DURCHLESEN.

®

Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: [phone]

www.koalabear.com

KB112-01RE COUNTERTOP BABY CHANGING STATION

INSTALLATION INSTRUCTIONS

Please Note:

To assure proper installation, it is suggested that a qualied person or carpenter install the Koala Baby

Changing Station. Koala Kare Products will not be responsible if the station is not installed properly.

Koala Baby Changing Stations are intended for use on an existing countertop surface that is capable

of holding signicant weight. Unit should be permanently mounted to the countertop surface per the

installation instructions. When an infant is placed onto changing surface, use strap and buckle to secure
infant to changing surface. Never Leave Child Unattended.

Restraint System: To fasten the waist restraint strap, place strap around child’s midsection, and push
spring tabs into buckle until both spring tabs lock in place with an audible “click”. Straps can be adjusted

to make strap tighter or looser as required.

You are responsible for the safe operation and use of this unit. Not intended to hold more
than 50 lbs.

Inspection Criteria:

A properly maintained baby changing station:

• Is free of any cracks or damage that can cause injury.

• Has two sides of a retaining strap free from damage.

• Check straps for wear. Buckle should lock with an audible click.

• Check labels and replace as needed.

TOOLS NEEDED

Gloves Phillips Head

Screwdriver

Drill 1/8” Drill Bit

(regular and
masonry)

Level Pencil

Measuring
Tape

HARDWARE PROVIDED

Saw

8 Screws 8 Screw Covers 8 Screw Cover Bases