KOALA KARE PRODUCTS
Installation and Operation Instructions
KB111-SSRE Baby Changing Station
Cambiador Plegable
Table à Langer
Babywickelstation
You are responsible for the safe operation of this unit.
IMPORTANT. RETAIN FOR FUTURE REFERENCE. READ CAREFULLY.
IMPORTANTE. GUÁRDELO PARA FUTURAS CONSULTAS. LEER ATENTAMENTE.
IMPORTANT. À CONSERVER POUR INFORMATION. À LIRE ATTENTIVEMENT.
WICHTIG. ZUR SPÄTEREN BEZUGNAHME AUFBEWAHREN. BITTE SORGFÄLTIG
DURCHLESEN.
Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: 303.539.8399
www.koalabear.com
OPERATING INSTRUCTIONS
Please Note:
To assure proper installation, it is suggested that a qualied person or carpenter install the Koala Baby
Changing Station. Koala Kare Products will not be responsible if the station is not installed properly.
Koala Baby Changing Stations have been tested to hold a substantial static load. The unit must be
attached to a permanent wall that is capable of holding a substantial load. The maximum recommended
total weight for this baby changing station (including baby and parcel bag) is 60 lbs. Excessive weight
may cause a hazardous or unstable condition to exist.
Restraint System: To fasten the waist restraint strap, place strap around child’s midsection, and push
spring tabs into buckle until both spring tabs lock in place with an audible “click”. Straps can be adjusted
to make strap tighter or looser as required.
Inspection Criteria:
A properly maintained baby changing station:
– Opens and closes smoothly
–
Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is attached to unit at
both ends.
– Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
– Provides a clean, convenient place for customers to attend to their children.
Screwdriver
TOOLS NEEDED
Gloves 9/16” Socket Wrench Level Pencil
Drill 1/8” Drill Bit
(regular and
Measuring
Tape
Stud Finder
masonry)
HARDWARE PROVIDED
Mounting Bracket Four Flat Washers
Four Acorn Nuts
Eight Phillips Flat
Head Screws