Koala Kare KB110-SSRE User Manual [en, de, fr]

KOALA KARE PRODUCTS

Installation and Operation Instructions

KB100-ST and KB110-SSRE Baby Changing Station

Cambiador Plegable

Table à Langer

Babywickeltisch

Your unit can be installed to meet ADA regulations when and where applicable. Refer to
Federal Register, Volume 56, No 144 28 CFR Part 36.

You are responsible for the safe operation of this unit.

IMPORTANT. RETAIN FOR FUTURE REFERENCE. READ CAREFULLY.
IMPORTANTE. GUÁRDELO PARA FUTURAS CONSULTAS. LEER ATENTAMENTE.
IMPORTANT. À CONSERVER POUR INFORMATION. À LIRE ATTENTIVEMENT.
WICHTIG. ZUR SPÄTEREN BEZUGNAHME AUFBEWAHREN. BITTE SORGFÄLTIG
DURCHLESEN.

Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: [phone]

www.koalabear.com

OPERATING INSTRUCTIONS

Please Note:

To assure proper installation, it is suggested that a qualied person or carpenter install the Koala Baby

Changing Station. Koala Kare Products will not be responsible if the station is not installed properly.
Koala Baby Changing Stations have been tested to hold a substantial static load. The unit must be
attached to a permanent wall that is capable of holding a substantial load. The maximum recommended
total weight for this baby changing station (including baby and parcel bag) is 60 lbs. Excessive weight
may cause a hazardous or unstable condition to exist.

Restraint System: To fasten the waist restraint strap, place strap around child’s midsection, and push
spring tabs into buckle until both spring tabs lock in place with an audible “click”. Straps can be adjusted
to make strap tighter or looser as required.

Inspection Criteria:

A properly maintained baby changing station:

– Opens and closes smoothly

Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is attached to unit

–
at both ends.
– Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
– Provides a clean, convenient place for customers to attend to their children.

TOOLS NEEDED

Gloves Phillips Head

Screwdriver

Drill 1/8” Drill Bit Measuring

Level Pencil

Stud Finder

Tape

HARDWARE PROVIDED

Four ¼”x 3” Phillips Panhead Wood Screws Four ¾” x ¼” Flat Washers