Koala Kare KB102 User Manual [en, de, fr, es]

KOALA KARE PRODUCTS

Installation and Operation Instructions

KB102 Child Protection Seat (CPS)

Silla de protectora para niños

Siège de sécurité pour enfant (SSE)

Kinder-Sicherheitssitz (KS)

You are responsible for the safe operation of this unit.

IMPORTANT. RETAIN FOR FUTURE REFERENCE. READ CAREFULLY.
IMPORTANTE. GUÁRDELO PARA FUTURAS CONSULTAS. LEER ATENTAMENTE.
IMPORTANT. À CONSERVER POUR INFORMATION. À LIRE ATTENTIVEMENT.
WICHTIG. ZUR SPÄTEREN BEZUGNAHME AUFBEWAHREN. BITTE SORGFÄLTIG
DURCHLESEN.

®

Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: [phone]

www.koalabear.com

OPERATING INSTRUCTIONS

Please Note:

To assure proper installation, it is suggested that a qualied person or carpenter install the Koala

Child Protection Seat.
Koala Kare Products is not responsible if the seat is installed improperly.

You are responsible for the safe operation of this unit.
Not intended to hold more than 50 lbs.

Inspection Criteria:

A properly maintained unit:

– Opens and closes smoothly
–

Has two end caps located on lower sides of unit.
– Has fastening nut located at end of rod.
– Has both ends of a functioning, non-frayed strap, buckle clicks when closed and strap is
attached at both ends of the unit.

Using Restraint System

When a child is in the seat, the strap runs from the seat bottom, between child’s legs, up to the
waist where it fastens to the shoulder straps. Shoulder straps extend snugly over the shoulders
and between the legs fastening at the waist. When the seat is open and child is in place, straps
should hold child securely.

Measuring
Tape

Gloves Phillips Head

Screwdriver

TOOLS NEEDED

Level Pencil

3/8” Drill
Bit

HARDWARE PROVIDED

Four ¼” Bolts and Washers Four Threaded Barrel Bolts

1

INSTALLATION INSTRUCTIONS

KB102 Child Protection Seat (CPS)

Model Number KB102

Step 1.

The Child Protection Seat (CPS) is
designed to be mounted on a bathroom

or tting room partition. The unit can also

be mounted on a side wall (hardware
not included). Establish proper CPS
placement, taking door swing and
clearance into consideration.

Step 2.

Place the bottom of the unit 2” (51 mm)
above the bottom of the partition or 14”

(356 mm) above the oor, whichever is

higher. Use the CPS as a template for
locating and marking the mounting holes.

Step 3.

After establishing the proper placement of
the four mounting holes, drill through the
partition using a 3/8” (10 mm) drill bit.

Step 4.

Insert the four threaded barrel bolts
(supplied) from the outside of the partition.
Mount the unit using the four ¼” (6 mm)
bolts and washers.

Step 5.

Position Koala sign (supplied) on
the outside of the restroom door.
Replacement parts can be purchased
from your local distributor or by calling toll
free 888.733.3456 or 303.539.8300 in the
U.S.

2