KOALA KARE PRODUCTS
Installation and Operation Instructions
KB100 Baby Changing Station
Cambiador Plegable
Table à Langer
Babywickeltisch
Your unit can be installed to meet ADA regulations when and where applicable. Refer to
Federal Register, Volume 56, No 144 28 CFR Part 36.
You are responsible for the safe operation of this unit.
IMPORTANT. RETAIN FOR FUTURE REFERENCE. READ CAREFULLY.
IMPORTANTE. GUÁRDELO PARA FUTURAS CONSULTAS. LEER ATENTAMENTE.
IMPORTANT. À CONSERVER POUR INFORMATION. À LIRE ATTENTIVEMENT.
WICHTIG. ZUR SPÄTEREN BEZUGNAHME AUFBEWAHREN. BITTE SORGFÄLTIG
DURCHLESEN.
®
Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: 303.539.8399
www.koalabear.com
OPERATING INSTRUCTIONS
Please Note:
To assure proper installation, it is suggested that a qualied person or carpenter install the Koala Kare
Baby Changing Station. Koala Kare Products will not be responsible if the station is not installed properly.
Koala Kare Baby Changing Stations have been tested to hold a substantial static load. The unit must be
attached to a permanent wall that is capable of holding a substantial load. The maximum recommended
total weight for this baby changing station (including baby and parcel bag) is 60 lbs. Excessive weight
may cause a hazardous or unstable condition to exist.
Restraint System: To fasten the waist restraint strap, place strap around child’s midsection, and push
spring tabs into buckle until both spring tabs lock in place with an audible “click”. Straps can be adjusted
to make strap tighter or looser as required.
Inspection Criteria:
A properly maintained baby changing station:
– Opens and closes smoothly
–
Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is attached to unit
at both ends.
– Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
– Provides a clean, convenient place for customers to attend to their children.
Measuring
Tape
Gloves Phillips Head
Screwdriver
Drill 1/8” Drill Bit
(regular and
masonry)
TOOLS NEEDED
HARDWARE PROVIDED
Four 1/4”x 3”
Phillips Panhead
Wood Screws
Stud
Finder
Level Pencil
7/32” Drill Bit
(regular and
masonry)
1/2” Drill Bit
(regular and
masonry)
Four 1/4”
Flat
Washers
1
INSTALLATION INSTRUCTIONS
Horizontal Baby Changing Station Surface Mounted
Model Number KB100 and KB110-SSWM
Step 1.
Remove changing station from the shipping container and check for any freight
damage. Identify the best location for installing the unit. Hold the unit in place
and open the bed. Make sure you have taken the operating clearance into
consideration.
Step 2.
Based upon the type of wall on which you will be mounting the station, determine
the best method of mounting. You may have left over hardware when you are
nished with installation.
Step 3.
The horizontal unit has four mounting holes provided in the back wall of the unit.
The four holes are positioned on a 32” (813mm) stud center.
If possible, locate the wood or metal studs for fastening the changing station in
the desired location. If the walls do not have studs on center as outlined, make
sure at least one side of the unit is installed into the stud. Use toggles (may have
to purchase) for holes on the other side.
2
INSTALLATION INSTRUCTIONS
Step 4.
Find the stud where you will be attaching the left side of the changing station
to the wall. Measure up from the oor 44” (1118 mm), at the center of the stud
and mark the wall. Mark holes using a level and measuring tape to make sure
holes are precisely positioned. Hold
unit in place to check. Use a 1/8”
drill bit to make pilot holes and
the four ¼” x 3” panhead screws
with washers (supplied) to attach
the unit to the wall studs. This will
place the bottom of the station
26½” (673 mm) from the oor and
the top of the bed at 33” (838 mm)
from the oor.
If the wall surface is masonry or
tile over wood studs, use a 7/32”
masonry drill bit for the pilot hole
until you hit the stud. Change bit to
1/8” regular drill bit. Use the four
¼” x 3” panhead wood screws with
washers (supplied).
If the wall has wood studs that
are not on 32” (813mm) centers,
has metal studs or an underlying
surface of concrete block, drill with a ½” (12 mm) masonry bit. (You may have
to purchase toggles before installing.) You must allow a minimum of inside wall
space for toggles to turn depending on toggles used. Insert and tighten toggles.
Step 5.
Position Koala sign (supplied) on the outside of the restroom door. Fill the built-in
dispenser with sanitary bed liners. Replacement parts and additional liners can
be purchased from your local distributor or by calling toll free 888.733.3456 or
303.539.8300 in the U.S.
3
ASTM F 2285-04
WARNING: Never leave child unattended.
WARNING: Avoid serious injury from
falling or sliding out. Always use restraint system.
WARNING: Designed for Infants Only.
Age up to 3.5 years and weighing less than 50
lbs. Keep one hand on the child at all times.
Parcels or accessory items, or both, placed on
the unit may cause the unit to become unstable.
ATTENTION : Ne laissez jamais un
enfant sans surveillance.
ATTENTION : Évitez les blessures
occasionnées par une chute ou une glissade.
Utilisez toujours le système de retenue.
ATTENTION : Conçue uniquement
pour les jeunes enfants. Jusqu’à 3 ans et demi
et moins de 50 lb (23 kg). Conservez une main
sur l’enfant à tout moment.
Tout paquet ou accessoire placé sur la table
peut créer un déséquilibre.
WARNING
WARNING
WARNING
WARNING
Koala Kare Products, A Division of Bobrick 6982 S Quentin Street Centennial, CO 80112
ADVERTENCIA: No deje nunca al niño
desatendido.
ADVERTENCIA: Evite que el niño se
lesione por caerse o resbalarse del cambiador
Use siempre el sistema de sujeción.
ADVERTENCIA: Diseñado
exclusivamente para bebés. Hasta 3 años y
medio de edad y con un peso inferior a 50
libras (22,5 kg aproximadamente). Mantenga
siempre al niño sujeto con una mano.
Colocar paquetes o accesorios, o ambas
cosas, encima del cambiador puede provocar
que se desestabilice.
Ph 888-733-3456/303-539-8300 - www.koalabear. com
Never leave child unattended.
Avoid serious injury from falling or sliding out. Always use
restraint system.
Designed for Infants Only. Age up to 3.5 years and weighing
less than 50 lb. Keep one hand on child at all times.
P/N 975
WARNING
WARNING
WARNING
WARNING
Koala Kare Products, A Division of Bobrick 6982 S Quentin Street Centennial, CO 80112
Ph 888-733-3456/303-539-8300 - www.koalabear. com
Never leave child unattended.
Avoid serious injury from falling or sliding out. Always use
restraint system.
Designed for Infants Only. Age up to 3.5 years and weighing
less than 50 lb. Keep one hand on child at all times.
P/N 975
WARNUNG: Das Kind niemals
unbeaufsichtigt lassen.
WARNUNG: Ernsthafte Verletzungen
durch Herausfallen oder Herausrutschen
verhindern. Immer das Rückhaltesystem
verwenden.
WARNUNG: Dieses Produkt ist
nur für Kleinkinder bis zu 3 1/2 Jahren und
einem Gewicht von höchstens 50 lbs. (23 kg)
vorgesehen. Das Kind immer mit einer Hand
festhalten.
Durch Ablegen von Päckchen und Zubehör auf
der Wickelstation kann diese instabil werden.
4