Koala Kare 876-KIT User Manual

KB100-ST, KB110 and KB111 REPLACEMENT SHOCK INSTRUCTIONS

Compress

Shock Down

P/N 874-KIT-ST (KB100-ST)

Materials Supplied: Tools Needed:

Shock Flat Head Screwdriver

P/N 875-KIT (KB110)

P/N 876-KIT (KB111)

Step 1.
Remove the baby changing station from the wall by unscrewing the
mounting screws from the inside of the unit. Place the unit face down

on a soft material (ex: a blanket) to protect the stainless steel fi nish.

Step 2.
The shock can be accessed on the back side of the station. On both
ends of the gas shock there is a “C” clip that holds the shock onto
the ball stud. To remove the gas shock carefully slide a Flat Head
screwdriver in-between the shock and the “C” clip at the top of the
shock. Once the tension on the “C” clip is removed you will be able to
pull the gas shock off the ball stud.

Step 3.
For recessed models, position the baby changing station on a
4” x 4” x 36” (102 mm x 102 mm x 914 mm) wooden block (or similar

surface) so that the trim fl ange around the unit hangs over the edge

of the block without touching the surface below. For wall mounted
models stand on a blanket or other soft material to protect the

stainless steel fi nish. Open the door of the baby changing station all

of the way. You should be able to locate the lower ball stud on the
bottom of the door. Use a long Flat Head screwdriver to release the C
clip on the lower ball stud, by inserting it into the shock opening.

Step 4.
Slide the thin end of the replacement shock down through the hole in
the back of the unit. Snap the replacement shock onto the lower ball
stud. Make sure the shock is secured to the ball stud by slightly twisting
the shock to make sure that it does not come unhooked.

Step 5.
Close the door of the Baby Changing Station all of the way. With
the door completely closed compress the shock so that it can be
attached to the upper ball stud. Snap the shock onto the ball stud.
Twist the shock to make sure that it does not come unattached from
the ball stud.

Step 6.
Open and close door of unit several times to make sure that the
shock is functioning properly and the door opens smoothly. Remount
unit following the proper installation instructions that were provided
with the unit. Open and close door several times after the unit has
been mounted. Close the unit after the shock has been tested.

Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: [phone]

www.koalabear.com

P/N 1024 May 2012