Knoll IR34 Installation Manual

IR34

DUAL MINI INFRARED

EMITTER

Information and
Installation Guide

To block remote control signals from other
emitters or local remote controls cut black
window mask to the component window size
and also cover IR34 cover plate.

Black Window Mask

IR34

IR34 Enlarged Side View

Clear adhesive layer.
Stick this side to
component window.
Replace adhesive if
necessary.

High output side.

Used when IR34
is not stuck on
component IR
window. Controls
components up
to 3’ (1m) away.

Wire

Low output side.

IR34 Plug and Wire Polarity

+ - +

-

Wire

Tip

Typical Installation

To IR55
connection
block

Receiver

Infared emitters low output
(flat) side attached directly
to IR sensor windows.

Cabinet Installation

Receiver

Note: In this mode, other IR
signals can pass through IR34’s
and control component. To stop
this cover the IR34’s and component
sensor window with black tape.

Shelf

Shelf

Note: In this mode, an emitter is
placed at the front of the shelf either
above or below the IR window. It is
less reliable than direct attachment
but looks better.

Cabinet Installation

Receiver
side view

Shelf

Shelf

Note: In this mode, an emitter
is attached to the door of the
equipment rack with the high
output side facing the component
IR window. Obviously the emitter
will be less reliable when the rack
door is open .

Equipment
Rack Door

IR34

IR34

Caution: Emitters can easily be
destroyed by connecting them
directly to a power supply or battery.

CD Player